1, six 50cm white 72nd jade wires are folded in half respectively, and then connected one by one, as shown in the figure.
2, put them away, it will be a little loose here, don't worry.
3. Use a white jade thread of 120cm to tie a diagonal knot on two threads of a group.
4. Use this winding to tie a diagonal knot on other 10 lines, so that the hole in the middle is narrowed.
5. In addition, take a 40cm 72 # green jade line and fold it in half, leaving about 5cm to make a snake knot.
6. The green thread passes through a 5mm agate bead, and then passes through the hole in the middle of the white diagonal knot made before.
7. Thread the green thread into 6mm agate beads and tie a knot. Cut off the excess thread and burn it.
8. The previous white winding continued to make oblique knots on the 12 axis, and it was tightened while doing it. The picture shows the third oblique knot.
9. Continue to knit oblique knots. After eight laps, there will be a big head and a small head.
10, when making the last diagonal knot, fold the shaft in half and make diagonal knots on these two lines.
1 1, 12 axes all do this.
12. Cut the winding and burn it.
13, take out one of the shafts and fix the one that can't be pulled.
14, a 40cm green jade line No.72, tie a bird's head knot on the fixed line.
15. After making the 15 bird's head knot, cut two more threads and burn them well.
16, push the bird's head knot to the end of the white axis.
17. Pull this shaft tightly and the green bird's head knot will form a leaf.
18. There are six leaves like this, and one leaf is made every other axis.
19. The other axis also uses the method of bird's head knot to make leaves, but this leaf made 20 bird's head knots with 50cm green No.72 jade thread.
20. The big leaves are also 6 pieces, which are separated from the small leaves.
2 1, tidy up, put the big leaves inside and the small leaves outside.
22. After all the white shafts outside were cut off, they were tightened and burned.
23, such a Chinese cabbage pendant is ready, very mini and beautiful!