The quality must be the manufacturer's own line is higher. Looking at it is dark and thick, you will know the weight, at least the material is enough; The custom line depends on the price and channel, and that thing is mixed. It is recommended to find a reliable merchant and not buy it too cheaply.

The original line really feels practical, and the custom line is mixed. It needs beauty and quality, so you can only follow your feelings. ?

Method for self-made module line

1. Mark the wire diameter in the gap of the wire stripper, press it in, and cut off the sheath, about 4mm, corresponding to the wire diameter.

2. Wire pressing: First, break a terminal and put it into pliers. If you press it a little, you won't stay. Then, insert the stripped wire and press it tightly.

3. To measure the line sequence, please use a multimeter and only use a buzzer.

4. The black probe of the multimeter is inserted into the first leg of the 24p terminal, and the red probe is connected with the psu power terminal (one of the terminals of 14p or 10p), and the multimeter chirps to record the connection.

5. According to the measured line sequence, insert the pressed wires into the rubber shell.

6. Short the 24p- 16 pin (pson) and 17 pin gnd, and measure the voltage of each pin of 24p with a multimeter, which must be accurate. The same is true for Cpu power supply and graphics card power supply.

7. Test on the computer.

Remember to measure your own original line and don't look for other people's drawings. Incorrect line sequence will burn out the power supply, motherboard, graphics card and hard disk.