Right dumping

1, adjust the initial position before unloading.

Shift 1 to lift the clutch forward, keep the car body parallel to the left side line, and the distance is 1.5m-2m. The front wheel should cross the control line, stop at the test starting point, and enter the reversing warehousing project. Tip: The edge of the left rearview mirror moves a similar distance along the left line.

2. Hang the reverse gear, release the clutch, see that the line under the right rearview mirror coincides with the yellow line, and kill the steering wheel to the right (the direction should be sooner rather than later).

3. Observe the right rearview mirror. When the right rear wheel is about 30cm away from the right corner, turn your head to observe the left rearview mirror.

If the angle between the right rear wheel and the right garage is less than 30 cm, it means that the direction is played earlier, and you can go back to the left in some directions, and then press back to the right when the distance is almost the same;

If the angle between the right rear wheel and the right garage is more than 30 cm, it means that the direction was played late just now, and it may have hit the left line. Observe the left rearview mirror immediately.

4. Observe the left rearview mirror, the car body is almost parallel to the garage sideline, and immediately return to the left and right.

In the left rearview mirror, observe the relationship between the car body and the left line of the garage. When approaching parallel, immediately return to the positive direction, and observe the left and right rearview mirrors when reversing, so as to fine-tune the direction and adjust the width from which side to which side.

Figure ii

Figure 3

5. Stop in time.

When you see the lower edge of the left rearview mirror blocking the horizontal line of the garage in front, immediately step on the clutch brake to stop.

Turn left (some examination rooms need to turn left when leaving the library)

1, shift to 1, lift the clutch, release the foot brake and leave the warehouse to the left.

Before leaving the warehouse, observe the left and right rearview mirrors, the distance between the car body and the left and right sideline, and the car body will start directly in the middle of the garage;

If it is not in the middle, turn from the wide side to the wide side. After starting, slightly adjust the direction to the wide side, and control the steering wheel angle within 15.