The symbol of a Swiss watch is the Swiss made logo on the watch. The most confusing thing is that there is only one word "Swiss". Most of these watches mean that they are brands registered in Switzerland, indicating that the brand is Swiss and the watch may not be made in Switzerland. Because only watches made in Switzerland can be Swiss watches.

Identification method:

1. Check the appearance of the watch: The appearance of the Swiss watch can be checked from the aspects of the case, cover, dial and hands. The Swiss watch case should be symmetrical with no scratches or blisters, and the back cover and case should be tightly screwed together.

The two pairs of holes for installing the watch strap spring should be centered and of appropriate depth to prevent the watch strap spring from falling off easily. The surface cover should be smooth and transparent, without scratches or defects. The coating on the dial and hands should be bright, and the minute and second scale lines and luminous dots on the dial should be perfectly illuminated.

2. Check the sensitivity of the watch: The sensitivity of a Swiss watch refers to how quickly the balance wheel in the watch starts on its own. If an unwinded watch is shaken slightly, the second hand will start and then stop quickly.

Or the second hand starts to move after only winding the clockwork two or three times, which shows the sensitivity of this watch. For high-frequency fast (pendulum) watches, due to the greater stiffness of the hairspring, it takes a few more windings and windings before the second hand moves. This is a normal phenomenon and does not mean that the sensitivity is low.

3. Check the efficiency of winding the watch: When winding a normal Swiss watch, your hand should feel gradually tightening. When the winding does not move, it means that the winding has been fully wound. If there is an abnormal sound of "chirping, chirping" when winding, or the stem slips, it indicates that there is something wrong with the winding part.

4. Check the gap and mutual position of the hands: There should be a certain gap between the hands of the Swiss watch and the dial and cover, as well as between the hour, minute and second hands, and they cannot rub against each other. Touch, otherwise it will affect movement.

Set the hour and minute hands to three o'clock, six o'clock, nine o'clock, twelve o'clock and other positions respectively. At three o'clock and nine o'clock, the two hands should form an angle, and at six o'clock the two hands should form an angle. Form several straight lines, and at twelve o'clock the two needles should be together. If this is not the case, the minute hand and hour hand are not installed correctly relative to each other.

5. Check the tightness of the Swiss watch when the minute hand rotates. Turn the minute hand and hour hand continuously for twelve hours. If there is no obvious feeling of looseness or tightness between the minute hand and the hour hand at each position of the twelve hours, it means that the needle movement part of the watch is installed normally.

6. Check the sound when you move: wind the watch a few times and listen to the sound when it moves. If the sound is uniform, clear and without noise, it means there is no major problem with the watch, because the watch Whether it is good or bad mainly depends on the accuracy of the actual travel time rather than the quality of its sound. Therefore, listening to the sound can only make a rough estimate of the quality of the watch.