Current location - Trademark Inquiry Complete Network - Trademark inquiry - The price tag of stainless steel basin is difficult to tear off. What should I do?
The price tag of stainless steel basin is difficult to tear off. What should I do?
1, wipe it with some alcohol (industrial alcohol is better, or medical alcohol can make do) with a paper towel, and then tear it clean after a few rubs.

2. Use acetone. The method is as above. The dosage is very small and thorough, and it is great that these residual gums can be removed very quickly and easily, and the effect is better than alcohol. Both of them are solvents, and the effect is better in the method.

3. Use nail polish remover. Usage is the same as alcohol acetone. The effect is also very good. Nail polish remover doesn't require quality, it's good and ordinary, as long as it can wash off nail polish.

4. Use hand cream. Tear off the surface print first, then squeeze some hand cream on it and rub it slowly with your thumb. After rubbing for a period of time, all the rubber residue can be wiped off. Take your time. Hand cream belongs to grease and its properties are incompatible with rubber. Glue removal is to take advantage of this feature.

5. Use banana oil. It is an industrial paint remover, and it is also easy to buy (where there is paint, there is it). The method is the same as alcohol acetone.

6. Mix the detergent with water and smear it on the label, which should completely soak the label; Then cover the label with plastic wrap, which should be completely sealed. Wait about 5 minutes to uncover the plastic wrap, and you can see the label fall off with a gentle pull. When doing these cleaning, you should remove the packaging on it, such as scraps of paper on the sticker or plastic film on the anti-counterfeiting label.

7. Apply essential balm to the residual rubber; A paper towel (or something that can be wiped, but cheaper) can be wiped back and forth. This method will make the residual glue thinner, but because of the oiliness of the wind oil essence, there is a greasy layer on the object. If you hate it, you can wash it again with greasy detergent.

8. soak in hot water for a while, or blow with a hair dryer, bake the glue and it will fall off, and then you can peel it off. It's cold in winter, and it's covered for a long time. It's better to uncover it when it's warm.

9. You can try it with an eraser. But at first, you may feel that the more you rub, the dirtier you get. But if you rub it for a long time, you will see the effect. This method is tiring and requires perseverance.