Current location - Trademark Inquiry Complete Network - Trademark inquiry - Measures to expose trademarks
Measures to expose trademarks
How can the addition of tableware be less in current home life? Nowadays, many tableware will be labeled after being bought back. These trademarks are difficult to remove, they look awkward and unsanitary if they are not removed. At this time, it is necessary for housewives to master a life trick and remove the trademark at the bottom of the pot!

How to remove the trademark 1,

First, tear off the self-adhesive decorations attached to the surface, soak the towel with warm water (hot water in winter), and repeatedly wipe the adhesive marks twice; Wipe the soap with a warm wet towel and rub it several times at the trace; Finally, clean the soap bubbles with a clean warm and wet towel, and the adhesion marks will be removed.

How to remove trademark 2,

Blow hot air on the edge of the trademark with a hair dryer for one minute, gently lift the trademark with your fingers and slowly tear it open. If you feel resistance, continue to blow on the torn mouth with a hair dryer, and the trademark will be completely removed in a moment.

How to remove the trademark 3,

Apply toothpaste evenly on the adhesive surface, leave it for a while, and then wipe it with a soft rag. Sometimes it sticks more and more firmly, and then toothpaste is applied to the traces that have not been removed once. The method remains the same, and the gel for headache can be removed. The principle is that toothpaste contains glycerol, which is a good solvent and can dissolve adhesive components. In addition, many cosmetics also contain glycerol, which can also be used to remove adhesives.

How to remove the trademark 4,

The effect of essential balm can also be achieved. If it is a self-adhesive or the like, you can also blow it with a hair dryer, which is very easy to remove.

How to get rid of the trademark 5,

Soak it first, gently peel off the paper on the trademark, and then squeeze in the detergent. Then gently rub with the iron slag of the brush pot, and it can be removed.