1, triangle valve or hose inner wire joint leaks;
2. Water leaks at the joint between the cold and hot water regulating switch and the hose;
3. The adjusting switch in the middle is leaking.
Note: When the storage water heater heats hot water, the water and a small amount of residual air in the water heater liner expand due to the heating volume, and the pressure in the whole water heater liner increases. In order to ensure safety, it is normal for the pressure relief valve to open "water leakage" to release pressure.
Second, how to repair the water leakage in triangle valve of Vantage water heater?
1, the raw materials of the package are getting old;
2, just put the raw material belt in;
3. It shows that the switch is not well sealed, and a brand-new triangle valve is needed.
Third, how to replace the Vantage water heater triangle valve?
1. When replacing triangle valve, be sure to turn off the power.
2. Connect the metal hose of triangle valve and remove it counterclockwise. Clamp the triangle position of the angle valve with a professional wrench and rotate it counterclockwise. Be careful not to use too much force to avoid slipping.
3. When installing, wrap 4-5 circles of raw material tape on the thread of the angle valve and tighten it clockwise from outside to inside. Turn clockwise, screw in the internal thread fittings in the pipeline, and the thread of the angle valve is exposed for 2-3 turns to complete the installation.