Current location - Trademark Inquiry Complete Network - Trademark inquiry - How to remove adhesion marks
How to remove adhesion marks
Method for removing adhesive:

1, eraser

For some adhesive traces left on the surface, you can also erase them with an eraser, and then remove the Mao Mao left by the eraser.

2. hair dryer

For the adhesive on plastic products, you can use the hot gear of the hair dryer to blow the adhesive hot, and then slowly tear it off. However, almost every family has a hair dryer and can get rid of the annoying label.

Step 3: Dilemma

Soak the towel with hot water first, then wipe it repeatedly at the sticky mark, then dip the towel with soap and wipe it repeatedly at the mark, and finally wipe the soap foam with a clean warm and wet towel.

4. Lemon juice

If these stickers stick to your skin, you can wipe them off with lemon juice.

5, hand cream

Hand cream can also achieve the effect of removing adhesive, because hand cream contains a lot of water, and water contains a certain amount of surfactant. This surfactant has good wetting, penetrating and dissolving ability, and can quickly penetrate between the adhesive and the surface of the object, thus achieving the purpose of cleaning. Some similar products, such as face cream, facial cleanser and detergent, also have certain effects.

Step 6 remove vinegar

We spread vinegar evenly on the adhesive with a cotton swab. Through the glass, you can immediately see the vinegar slowly spreading between the glass and the adhesive. Then scrape the glue back and forth with a cotton swab. Soon, the glue began to peel off one by one, and there were few glue residues on the glass. Wiped with paper, as bright as new.

7, edible oil removal

Spare a spoonful of cooking oil, and then spread it evenly on the label (fragile labels will lose their viscosity under the action of oil). After 3~5 minutes, you can tear it slowly from the corner of the label directly by hand, so as not to leave traces of the label.

8, nail polish remover

Nail polish remover, to deal with the sticky marks on the surface of hard objects, such as stainless steel pot or glassware, apply a small amount of water on the fragile label as a whole, and gently scrape off the label that will fall off with your nails. Then dip a cotton swab in a small amount of nail polish remover and apply it to the residual glue on the label. 1~2 minutes later, rub it gently and the residual glue will fall off.

9, alcohol removal

The effect of these solvents is not obvious. After applying the solvent, we also need to wipe off the residue on the glass. But when alcohol was used, things changed immediately. As soon as we brushed alcohol on the glue on the glass, we immediately saw that the glue slowly softened and dissolved. Gently lift it with your hand and the glue will leave the glass cleanly. You can also use safflower oil and gasoline to remove these traces.

Extended data

Cleaning method

1. First, tear off the self-adhesive decoration attached to the glass or commodity surface, soak the towel with warm water (hot water in winter), and repeatedly wipe the sticky marks twice; Wipe the soap with a warm wet towel and rub it several times at the trace; Finally, clean the soap bubbles with a clean warm and wet towel, and the adhesion marks will be removed.

2. Apply toothpaste evenly on the adhesive surface, leave it for a while, and then wipe it with a soft rag. Sometimes there is more adhesive, and it is stronger. Just apply toothpaste to the traces that have not been removed once. The method is still the same, and the headache glue can be removed.

The principle is that toothpaste contains glycerol, which is a good solvent and can dissolve the components of adhesive. In addition, many cosmetics also contain glycerol, which can also be used to remove adhesives.

3. And scrape the hard bottom surface suitable for glass, floor tiles and the like with a pen and a paper knife; Wipe with alcohol, suitable for glass, floor tiles, clothes, etc. Freezing, after freezing, the glue becomes hard and can be torn off directly, which is suitable for alcohol, scraping and other methods.

It is said that it can also achieve the effect of wind oil essence. If it is a self-adhesive or the like, you can blow it with a hair dryer, which is easy to remove, but it is not suitable for plastic, and overheated plastic will be deformed.

5. Blow heat with air duct. This is very effective and convenient at home. Basically everyone has an air duct blower, which can stick glass, plastic, wood and metal. Blow it back and forth with the air duct several times, then tear a small edge, and slowly tear it along the direction of tearing while blowing with the air duct. The effect is very good.

6. Rub hard with an eraser.

7. It is very easy to remove it by wiping with Tinea water in industry.

References:

Baidu encyclopedia-stickers