According to the different objects for which trademarks are used, trademarks can be divided into: commodity trademarks and service trademarks.
Legal Analysis
If the flow rate is far lower than the minimum flow rate to ensure accuracy, it will result in no output (such as a vortex flowmeter) or the output signal will be cut off as a small signal. (such as differential pressure flowmeter), this is unfavorable to the supplier and unfair. In order to prevent the loss of benefits, for a specific set of heat energy metering equipment, the supply and demand parties often agree on a certain flow value as the "agreed lower limit flow" based on the flow measurement range and the reachable range, and agree that if the actual flow is less than the agreed value , charged according to the lower limit of charging traffic. The metrological administrative departments of the people's governments at or above the county level may set up metrological verification institutions as needed, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the calibration and testing tasks specified in the preceding paragraph must pass the assessment. This function is usually implemented in flow display instruments. The metrological administrative department of the local people's government at or above the county level shall establish public measuring standard instruments based on the needs of the region, and they shall be used after passing the assessment conducted by the metrological administrative department of the people's government at the higher level. Enterprises and public institutions may, according to their needs, establish measurement standard instruments for their own use. Their highest measurement standard instruments shall be used after passing the assessment conducted by the measurement administrative department of the relevant people's government. Metrological verification work should be carried out locally and nearby in accordance with the principle of economic and reasonableness. Metrology verification must be carried out in accordance with the National Metrology Verification System Table. The National Metrology Verification System Table is formulated by the metrological administrative department of the State Council.
Legal basis
"Trademark Law of the People's Republic of China" Article 3 Trademarks approved and registered by the Trademark Office are registered trademarks, including commodity trademarks, service trademarks and collective trademarks , certification trademark; the trademark registrant enjoys exclusive rights to the trademark and is protected by law. The term "collective trademark" as mentioned in this Law refers to a mark registered in the name of a group, association or other organization for use by members of the organization in commercial activities to indicate the user's membership in the organization. The term "certification trademark" as used in this Law means that it is controlled by an organization with the ability to supervise certain goods or services and is used by units or individuals other than the organization to certify the origin of the goods or services. , raw materials, manufacturing methods, quality or other signs of specific quality. Special matters concerning the registration and management of collective trademarks and certification marks shall be stipulated by the industrial and commercial administration department of the State Council.