Why does the labeling machine wrinkle when used? The operating technology should have the following points. The operator must have skilled operating technology and be very familiar with the operating procedures, otherwise it will directly affect the labeling quality. During operation Operation and production must be carried out in strict accordance with the operating procedures. Illegal operations are strictly prohibited. The operating procedures must be kept in mind at all times to avoid quality accidents or other accidents due to improper operation. During the operation, special attention should be paid to several technical points: Glue labeling. Scraper adjustment. According to the viscosity of the label glue and the labeling situation, adjust the amount of glue scraper to make the glue thickness moderate. If the glue is too thin, the label will not stick to the bottle, or the label will stick to the bottle but after passing the brush, the label will bounce up and become warped. It is ugly, and the trademark is easily squeezed out. If it is too thick, the trademark will move when passed by the brush after being applied, and the trademark will be skewed, which is ugly. Especially when applying the aluminum cap label, the thickness of the label glue is very important, because the aluminum cap label It is very thin and easy to be damaged. If the glue is thinner or the viscosity is lower, the label will easily fall off or become distorted when the black center of the bottle is pasted or brushed. If the glue is thicker or the viscosity is higher, the label drum will be removed from the label. It is easy to crack or damage the label when clamping it on the label board. After passing through the brush, it will be brushed off or torn, so the amount of scraper advancement must be adjusted immediately according to the actual situation. Increase the amount of trademarks at any time according to the amount of trademarks in the label box. When adding labels, the bundled trademarks should be loosened and loosened to prevent them from sticking to each other. When taking out the label from the label board, either it cannot be removed or double or multiple sheets will appear. The glue stick stuck on the label. When applying the label, you should be diligent in applying the label. Do not apply the label until the label box is full or there are very few labels in the label box. This will cause the label paper in the label box to be removed. The pressure on the target plate will increase and decrease at one time. When taking out the target plate, the target will either fall off or cannot be taken out, especially for aluminum cap tags. When the pressure on the target paper is too high, the target paper will stick tightly to the target plate. The label drum is easily damaged when picking up the label paper from the label plate, causing the label to not stick. The mark is missing and the pressure is low. The mark paper and the mark taking plate seem to be in contact with each other. The mark paper is loosely adhered to the mark taking plate. There is very little glue on the mark. After the mark paper is glued to the bottle, the black heart moves towards the bottle. When labeling, the hair falls off or becomes crooked, or the label cannot be picked up at all. When labeling, adjust the elastic force of the coil spring on the label according to the actual situation to avoid excessive pressure on the label when labeling. Or too small. During operation, you should always pay attention to the feeding situation of the label paper in the label box to adjust the tightness of the catch hook. The tightness of the catch hook must be appropriate. If the catch hook is too loose, the label paper will fall off easily. If the catch hook is too tight, the label paper will fall off easily. If the standard paper cannot be inserted and cannot reach the target plate, and the tension of the hook is not adjusted in time, the same phenomenon as above will occur.