Current location - Trademark Inquiry Complete Network - Trademark registration - How to Correct the Balance Axle of Toyota Previa 6?
How to Correct the Balance Axle of Toyota Previa 6?

If there is a mark on the gear surface of Toyota Prievia 6, will it be fine? There are timing marks on the balance shaft gear, and the two points are opposite. There are also marks on the big gear corresponding to the marks on the crankshaft.

Toyota Previa is an MPV produced by Toyota since 199. It is called Estima(エスティマ) in Japanese market, Tarago in Australia and Bullet, Overlord and Super Overlord in Chinese mainland.

the secret of PREVIA is to provide enough space, and at the same time ensure excellent flexibility, and be able to adjust and use the interior space according to your own wishes.

Previa's integrated design concept (One-motion Style) gives consumers a lot of room for use and imagination, and the new generation of styling is more distinctive than before. In particular, the very avant-garde MASK-shaped headlights are not only very sharp in vision, but also integrate the most popular HID gas discharge headlights in advanced cars, supplemented by the active steering AFS system.

In addition, the design of the water tank shield also matches the styling lines of the headlights, forming a recreational vehicle with a small area occupied by the water tank shield of the commercial vehicle, subverting the previous intuitive view that the water tank shield represents style, and the brand-new head styling design has also become the registered trademark of the new Previa.

New Previa's lamp group is very special. This trendy and avant-garde streamline design is also a continuation of the previous generation's eagle-eye shape, and the sharper lines are integrated in the lamp group, which makes it possible to obtain more efficient and safe lighting effects at night. The side of the car body is changed to the double diagonal design of the previous generation, and the slightly higher waistline extends from the end of the headlight to the rear of the car, creating the vision of a thick car body.

The taillight group also combines LED with traditional light bulbs, and the lines are similar to those of headlights, and the taillights on both sides are connected by reflectors to make it more integrated, especially in the center of the rear bumper. The original factory specially added a rear fog lamp at this position to provide driving safety in bad weather.