The toilet seat removal and installation methods are as follows:

Materials/Tools: Wrench, soft ruler, screwdriver.

1. Find the screw cap. The toilet seat is fixed with screws. At this time, you only need to find the screw cap, use a wrench to remove the screw, and then replace it with a new one. It is easy to install the screw cap in the open place. Unscrew it directly. The screw cap installed in a dark place cannot be seen. It is usually located on the side of the water tank in the toilet. You can usually find it by touching towards the water tank after opening the cover.

2. Remove the fixing bolts. If the toilet is fixed with fixing bolts, when replacing the toilet seat, you only need to remove the fixing bolts at the rear of the toilet to remove the toilet seat. After measuring the size, screw hole distance, width and length of the toilet seat, purchase a new toilet seat for replacement. Just tighten the screws in the opposite direction during installation.

3. Unscrew the bolts. Different styles of toilet seats are installed differently. The bottom of the toilet seat connected to the toilet is fixed with screws. Just reach behind the toilet and find it. By unscrewing the screws on both sides, you can take off the entire cover and then replace the toilet seat. This method is also the simplest.

Notes on choosing a toilet

When choosing a toilet, you should pay attention to whether the color of the toilet should be consistent with the color of the bathtub and washbasin. The color should not be darker than the floor tiles, and the tone should be consistent with the wall tiles. Coordination. The glaze of the toilet should be clean and smooth, with a crystal clear color and no obvious defects. There should be no pinholes or missing glaze. It is better to make a crisp and pleasant sound when tapping the toilet without cracking. There should be no cracks. The trademark should be clear and all kinds of accessories should be complete. No deformation of appearance, etc.

The water outlet of the bathroom can be divided into lower drainage and horizontal drainage. The distance from the center of the drainage outlet to the wall behind the water tank must be measured, otherwise the toilet cannot be installed. The water outlet of the horizontal drainage toilet must be in line with the horizontal drainage outlet. The height of the toilet is the same, preferably slightly higher, to ensure the smooth flow of sewage. Today, with water bills gradually rising, the water-saving performance of the toilet is particularly important.