Current location - Trademark Inquiry Complete Network - Trademark registration - What toys can water pipes make?
What toys can water pipes make?

Water pipes can be made into toy chairs, toy beds, toy figures, birdcages, toy guns, etc. A water gun can be invented. You can also invent a bucket. In fact, generally speaking, the biggest use of water pipes is for home decoration and to conduct water. But under normal circumstances, water pipes can still be used to make some decorations. For example, with slight modifications, they can be used to make flower pots. .

How to make water pipes

Installation of clothes drying rack and top base. After the position is determined, use an electric drill to drill holes. After drilling the holes, use expansion screws to fix the four top seats. If the rod length is larger than the regular size, adjust the length accordingly. Install corners. The corner can be installed on the top of the balcony or the top of the wall. The corner is 50 to 70cm away from the movable top base. A 45-degree angle must be formed in the triangle in the middle of the movable top base, and the same vertical line must be maintained with the hand-mounted position.

Steel wire connection. A set of water pipe clothes drying racks contains two steel wires. Take out one first, and first pass one end of the steel wire through the bearing wire groove at the corner, then through the movable wheel bearing steel wire groove at the top of the movable end, and then through the top seat at the fixed end. Make the steel wire perpendicular to the ground through the bearing steel wire groove, then insert the top cover through the steel wire and lock the top cover. The same goes for the other end of the wire.

The installation method of the other steel wire is the same as the first one. Let the connection dry. Thread a hanging ball through the end of each steel wire, tie a knot in the hanging ball, and then pull the hanging ball until it bears against the top base. At this time, pull the steel wire from the corner position to form a double-stranded steel wire, which is stuck in your hand. On one side of the hand crank, loosen the steel wire in the hand crank, lower the hanging ball, pass the hanging rod through the hanging ball, then tighten and fix it in the hole of the hanging ball, nail the screws, and finally install the hanging rod at both ends. Put on the plug.