Current location - Trademark Inquiry Complete Network - Trademark registration - How to remove offset printing from plastic bottles?
How to remove offset printing from plastic bottles?
1, apply face oil, spread it evenly, dig it off with your nails first, and then wipe it off with a wet towel.

2. Blow with a hair dryer and bake the glue to get rid of it.

3. Wipe it with wind oil essence, and it will fall off after a while.

4. You can try the eraser. But at first, you may feel that the more you rub, the dirtier you get. But if you rub it for a long time, you will see the effect. This method is tiring and requires perseverance.

5, soak in water, put a little detergent, and then brush with an old toothbrush.

6. Wipe with a cloth dipped in alcohol or spirit Erguotou.

7. Wipe it off with a little sodium chloride or paint thinner.

8. Wipe with a cotton swab dipped in nail polish remover.

9. Soak a paper towel in vinegar, then gently stick it on the double-sided tape for three or four minutes, so that the double-sided tape can be fully absorbed, and then gently peel it off without affecting the door. You don't need too much vinegar, as long as it can make the double-sided tape wet. After peeling it off, wipe the wall with a clean paper towel and gently print it.