The steps of carving cherry blossom patterns with rubber stamp are as follows:
Material preparation: 1 rubber, 1 sulfuric acid paper, 1 pen knife, paper cutter, pencil and 1 cherry blossom pattern material.
1. Take out the sulfuric acid paper and tick out the cherry blossom pattern with a pencil.
2. After the transfer is completed, cover the sulfuric acid paper on the rubber and scrape it hard.
3. After the transfer is completed, it can be engraved. First, engrave the side close to the line.
4. Turn the rubber when carving the arc.
5. Lift the knife slightly between the two petals.
6. Then carve the periphery of the flower.
7. Carefully carve out the petals, and cut off the center circle of the petals.
8. Cut off the surplus with a knife, and the cherry blossoms will be carved.