Current location - Trademark Inquiry Complete Network - Tian Tian Fund - Where is the pressure and support of macd and how to judge it?
Where is the pressure and support of macd and how to judge it?
First, judge the support and pressure according to the fluctuation amplitude. Methods: Golden section method.

1, at the 1 mark, the golden ratio is 6 1.8%, which has produced a strong rebound in this place. 80.9% has no support, and a big yinxian line directly falls below, indicating that it is more effective to fall a little more support.

2. In Mark II, the proportion of gold is 38.2%, which actually creates a big market in this place, mainly the rare earth market. You can look at the trend at that time.

3. In mark 3, the golden ratio was 80.9%, which became the pressure point of rebound and eventually triggered a big bear market.

4. In mark 4, the golden ratio is 23.6%, which has caused a wave of rebound before falling to this position.

If we take 5 178 as the end of the cycle, I believe everyone can also get the support pressure in the later period.

5. Assuming that 1849 is the starting point of the cycle and 5 178 is the end point of the cycle, I believe everyone can also get the support and pressure in the later period. On July 9th, 2065438+05, it began to rebound at the golden section of 50%. Those who are interested can draw by themselves.

Second, judge the support pressure according to the intensive transaction area in the early stage. Methods used: top-down and interval judgment method.

1.201When the Dayin Line came out on February 9, 4, the lowest price was lower than 201February 9, 8 10. Although the Yangxian Line was closed on February 9, 2065438 (the figure won 2 places), it can be concluded that there was a callback, marked as 65438. From the pressure point of view, the late rebound depends on whether it can break through the 1 mark and carefully form a double top. The trend tells us that it is not.

2. The meaning of mark 3 is the same as that of mark 1, and the meaning of mark 4 is the same as that of mark 2. Similarly, the rebound from 4 depends on whether you can break through the 3 mark and carefully form a double top.

3. When12, 23, 34 and 45 came out, we can find that the trends of these plates are overlapping. See the rectangular part of the fan in the figure. This section is called interval, which is the most important basis for judging the pressure and support in the later period.

4. The callback starting from 5, the stage high point starting from the first rebound 3 (see the arrow extending from 3); The second position to start rebounding is the stage high point 1 (see the arrow extending from 3); The third rebound place is the position extending in the middle of the rectangle. At the same time, from the pressure point of view, the first rebound (6 mark) depends on whether it can break through the 5 mark and carefully form a double top; The second rebound (Pass 7) will see if you can break through Pass 6 and carefully form a double top;

5. As for the third rebound, it is normal to rebound from any position in the top, middle and bottom of the interval (fan-shaped rectangle), which is its strong support interval. Only from the position where the rebound begins can we determine whether the trend is strong or not. Obviously, the top or even above is the strongest, and the bottom or even slightly below is the weakest.

6. The rebound occurred at 1 and 3, but the rebound generated by its support was weaker than that generated by the interval support.

Third, the trend line formed according to the high and low points of the trend. The method adopted: channel line method.

1. After rising from 2046 marked with 1, it entered an obvious upward trend. After rising to mark 2, it was slightly adjusted back to a new high and then adjusted back to 3. At this time, you can draw the channel line. The reason why the higher position between mark 2 and mark 3 is not used as the upper pressure level here is because if you draw it like that, you can't include the part of Contrast 2 now.

2. After the channel line is drawn, it continues to rise until the position marked by 4 is close to the channel line, which is the pressure, so it begins to fall; Call back to the position marked with 5 near the bottom of the channel line, which is support, so it begins to rise.

3. After rising to the 6 mark, the pressure on the upper rail of the channel began to drop at a distance, which is not a good phenomenon, indicating that the short-term increase is weak.

4. The decline from the No.6 mark fell below the lower rail support of the original channel line, and a new rise began from the No.7 mark. At this point, the channel line is destroyed and the original channel line is no longer valid.

5. The new channel line becomes a new channel line, with Mark 3 and Mark 7 as the channel lines to support the lower rail, and which of Mark 4 and Mark 6 is the upper rail of the channel line that can contain the trend from Mark 3. (As for why not use the nearest signs 5 and 7 to draw the lower track of the channel, because that would be out of the trend.)

6. Conversion between the support and pressure of the channel line In the above example, it means that the lower rail of the channel line changes from the original support to the pressure, specifically, it rebounds from the mark 7 in the figure. The lower rail of the original channel line has been transformed, but it has been successfully broken through.