The stacker is an ideal equipment for loading and unloading in overhead warehouses and workshops. Compared with forklifts, it saves more costs, can carry goods within two tons, and the lifting height can reach more than six meters. So how is the stacker made?

firstly, the automatic welding device is used to weld the steel components together to create the car body frame of the stacker. Then the workers make the railing manual welding machine into the main engine of the stacking system, and then spray the car body skeleton and the main engine with a beautiful protection period, so that they can carry out the next wave of assembly procedures. Install the emergency switch at the front end first, so that the stacker operator can cut off the power supply quickly. Then, the hydraulic system of the stacker should be assembled. Before that, we should start with the oil tank filled with hydraulic oil. Workers should connect the oil tank to the pump that provides pressure, and then install the pipeline of the pump so that he can be connected to the battery pack of the stacker. After adjusting the correct position of the pump, he should be fastened and fixed on the chassis.

Secondly, install the light horn and the sensor pipeline of the stacker, and then install the pedal to the designated position, which can start or stop the stacker. Then install an engine with horse power. Although the engine looks small, it is enough to move the whole car body and two tons of goods safely. Subsequently, the worker installed a bracket for the control rod of the vehicle, and then connected the control rod to the computer system, which can operate the car body and the leaf bud stacker at the same time. Then install the steering wheel on the rotating shaft and fix it firmly. Workers start the engine and check whether the steering function of the steering wheel is normal. Next, put the filtered oil into the hydraulic system of the stacker, which can ensure that the hydraulic system will not be damaged by any dust. Then the workers start the engine to test the computer control of the stacker and motor.

thirdly, after installing the hydraulic roller, workers will apply lubricating oil to the main frame, so that the ghost can easily slide into the main frame and improve the function of the stacker. Then the transmission chain is embedded in the main frame and the inner rail, and the chain will lift the goods together with the stacking drum. Then roll the bracket of the stacker along the groove of the track system, then the forks and other parts will be installed on this bracket, and then the stacker will be rotated by the machine to make it stand upright. Workers are pushing to install a complete car body and firmly tie him and the stacker. Then the assembled stacker is moved and assembled together, labeled, and the serial number and product parameter information are engraved on the metal plate, and finally the cover plate of the car body is covered, and the stacker is manufactured.