The sticky pot the brothers used to make wine is poisonous. Because the two brothers prefer to use modified resin glue, which has extremely low toxicity to the human body. However, the toxicity of the glue will increase when it is heated, so it is not recommended to be used for gluing tableware. Brother Hao is a chemical product and contains slight toxins. This toxin will not cause long-term harm to the human body. It can only make you feel a little uncomfortable for a short time, so try not to use it.

Brother's Good Glue is a two-component AB reactive structural adhesive synthesized by advanced technology. It has the following characteristics. It is easy to use, does not require strict measurement, can be used for oil surface bonding, and can be quickly cured and bonded at room temperature. It has high bonding strength, good acid and alkali resistance, water and oil resistance, high and low temperature resistance, and good aging resistance.

How to use Gelianghao Glue

Gelianghao 302 glue can stick to steel, iron, aluminum, titanium, stainless steel and other metals. Gelianghao 302 glue is a structural adhesive, mainly used for rigid bonding. Its characteristics are that it is easy to use, does not require strict measurement, can be used for oil surface bonding, can be quickly cured at room temperature, and has high bonding strength.

When using Gelianghao 302 glue, you need to polish it to remove the loose attachments on the surface, increase the roughness of the bonding surface, increase the bonding area, and increase the inlay effect between the colloid and the adhered surface. , increasing the bonding strength. If the bonding surface is too small to bear the load, you can consider patching, that is, strengthening the butt joint. You can add a piece of corresponding material on the outer surface of the glue joint to increase the bonding area.

Grinding can remove the attachments that are not solid on the surface, increase the roughness of the bonding surface, increase the bonding area, increase the mosaic effect between the colloid and the adhered surface, and increase the bonding strength.

Hole repair. Use a drill bit with a slightly larger diameter to drill the hole, and then cut a length of iron rod slightly longer than the hole depth and slightly smaller in diameter than the hole diameter, with a gap of 0.5 to 1 mm. After the iron rod is surface-treated, it is glued into the hole. Fillers such as iron red, iron powder, and aluminum powder can be added to the glue to reduce shrinkage and increase airtightness.