Handmade snowboards are generally characterized by exclusive design and high-end craftsmanship, and professional skiers are basically limited-customized handmade snowboards.

First of all, workers choose two kinds of wood as the core board, one is poplar and the other is pine. Depending on the width of the skis, the workers glued eight to ten boards together. These wooden floors are stronger than solid wood. They are pressed by a press for two hours, and the glue will gradually solidify in the process. Then take the board out of the press and cut it into strips with a band saw. Each one is the core board of the snowboard, and each home plate can be made into six core boards. Then the worker will trim the shape of the snowboard with a trimmer according to the outline template of the snowboard. Workers use welding torch to heat UHMWPE tape so that it can be bonded with other substances.

Secondly, workers covered it with a layer of epoxy resin and glued adhesive strips on both sides of the core board, thus making a solid snowboard side wall. After epoxy coating, the front and back of the snowboard were sawed into small pieces of 15 cm, and both ends were polished by hand. Then the worker heats the side wall again to prepare for the subsequent bonding and bonds it at the front end of the wood core board. Rubber plate can prevent the adhesive parts from scattering in the production process. Workers then use manual flat grinding to print the brand bonding trademark information at the ultra-high paper distance, and cut the same letters with white, which is the base of the snowboard.

Third, the left and right bases are coated with epoxy resin, and a layer of glass fiber that can lens epoxy resin is added, and a core plate is placed on it. The core plate and the pointed pad are also covered with epoxy resin, and glass fibers are also placed. Glass fiber is mainly used to install straps, that is, devices for fixing ski shoes. Place a steel plate where the strap is installed, and then cover the snowboard with a layer of glass fiber and a layer of nylon material with graphics on it. A series of metal plates and silicon heating plates are placed above the assembled fittings.

Fourth, put a whole set of wooden boards under the press, start the press, and the rubber airbag will inflate, turning the wood into the shape of a snowboard. After half an hour, the workers took out the skis, sawed them with a band saw, and trimmed their heads and tails with a curve saw. This is the edge of the snowboard, which is very rough, so the workers have to polish the edge around. Then they sharpened the side walls, which made skis. There is better edge grip in the snow, and the last step is to protect the nanny of nylon top layer in the past production process. This hand-made snowboard comes in several different sizes and models, so the snowboard is made.