It can be the same or different. There is no hard and fast rule that the brand name and the name of the mall store must be the same.

Legal Analysis

If the flow rate is far lower than the minimum flow rate to ensure accuracy, it will result in no output (such as a vortex flowmeter) or the output signal will be cut off as a small signal. (such as differential pressure flowmeter), this is unfavorable to the supplier and unfair. In order to prevent the loss of benefits, for a specific set of heat energy metering equipment, the supply and demand parties often agree on a certain flow value as the "agreed lower limit flow" based on the flow measurement range and the reachable range, and agree that if the actual flow is less than the agreed value , charged according to the lower limit of charging traffic. The metrological administrative departments of the people's governments at or above the county level may set up metrological verification institutions as needed, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the calibration and testing tasks specified in the preceding paragraph must pass the assessment. This function is usually implemented in flow display instruments. The metrological administrative department of the local people's government at or above the county level shall establish public measuring standard instruments according to the needs of the region, and they shall be used after passing the assessment conducted by the metrological administrative department of the people's government at the higher level. Enterprises and public institutions may, according to their needs, establish measurement standard instruments for their own use. Their highest measurement standard instruments shall be used after passing the assessment conducted by the measurement administrative department of the relevant people's government. Metrological verification work should be carried out locally and nearby in accordance with the principle of economic and reasonableness. Metrology verification must be carried out in accordance with the National Metrology Verification System Table. The National Metrology Verification System Table is formulated by the metrological administrative department of the State Council.

Legal Basis

Article 57 of the Trademark Law of the People’s Republic of China and any of the following acts shall constitute an infringement of the exclusive right to use a registered trademark: (1) Using a trademark that is the same as its registered trademark on the same kind of goods without the permission of the trademark registrant; (2) Using a trademark that is similar to its registered trademark on the same kind of goods without the permission of the trademark registrant, or using it on similar goods Using a trademark that is the same as or similar to its registered trademark on the Internet, which is likely to cause confusion; (3) selling goods that infringe the exclusive rights of a registered trademark; (4) forging or making without authorization the registered trademark signs of others or selling forged or making without authorization registered trademark signs (5) Changing the registered trademark without the consent of the trademark registrant and putting the goods with the changed trademark into the market; (6) Intentionally providing facilities for infringement of other people's exclusive rights to trademarks and helping others to infringe the exclusive rights of trademarks Behavior; (7) Causing other damage to others’ exclusive rights to registered trademarks.