Debugging steps:

1. Adjust the upper hand wheel of the manual hot stamping machine to the required pressure.

2. Set the pointer of the manual hot stamping machine to the required temperature. After 2-3 minutes, the green light will turn off and the red light will turn on. Automatic temperature control will always control the temperature at the set temperature point.

3. Put a layer of universal glue on the electrical board to be hot stamped, place the glue upward on the table where you want to place the product, and press down the actuator plate of the manual hot stamping machine for a few minutes.

4. After the hot stamping paper is installed and powered on, press the manual hot stamping machine and the paper will automatically pass through one stroke. The length of the automatic paper passing stroke is controlled by a 0-10 second delay relay.

5. Place the product on the manual hot stamping machine and put it on the paper plate for hot stamping.