1. Powerful Ceramic Cleaner: It is a very corrosive strong acidic detergent that can corrode cement stains, scale, and stains. Powerful Cleanser has a corrosive effect on the surface of objects and is suitable for After building decoration, rough stone surfaces and land reclamation will damage the building decoration materials if used improperly. They must be used with extreme caution and must be approved by the department supervisor before use; 2. Jie Porcelain Cleaner (Toilet Cleaner) 1. Commonly used cleaners in toilets , has the functions of decontamination, deodorization and sterilization; 2. Usage: Rinse the surface to be cleaned with clean water, apply the appropriately diluted product to the surface, scrub with nylon, and then rinse with water; 3. Precautions: Use Before using porcelain cleaner, do not put porcelain cleaner on the marble countertop of the wash basin because porcelain cleaner is an acidic solution. If you accidentally drip porcelain cleaner on the marble countertop or floor, it will corrode the marble. Make it lose its luster; 3. 105 stone water: 1. Usage: Generally, if there are stains, yellow stains, etc. on the surface of marble, marble, and granite, apply potion on the surface and cover it with a towel. After a period of time, the stone will Stains and yellow stains are decomposed and sucked out of the stone surface by the potion; 2. Note: This potion is an acidic potion, so it should not be too much on the surface of the stone. If it takes too long, it will easily affect the surface of the stone; 4. Hydrochloric acid: 1 , It is a strong acidic cleaner with strong penetrating and corrosive ability to cement. It is suitable for cleaning rough stones in land reclamation. It is highly corrosive. Improper use will cause damage to building and decoration materials. Wear rubber gloves when using. It can be used only with the consent of the supervisor; 2. Notes: All highly corrosive cleaning agents, such as caustic soda, powerful porcelain cleaners, rust removers, hydrochloric acid, etc., should be sprinkled with clean water on the surface of the object before use, and then diluted to a certain proportion. For the sake of safety, when using strong corrosive cleaners, it is best to try them on a small scale first and observe the effect before deciding whether they can be used on a large scale. Wear rubber gloves, water shoes, etc. when using them. 5. Rust remover: It is an acidic cleaner with strong ability to remove rust and oil stains. It has corrosive effect on metal, stone and so on. Be cautious when using it. 6. Bleach: A widely used cleaner with It has a bleaching and sterilizing effect, is slightly acidic, and is not easy to damage the stone surface. It can be used to remove yellow stains on toilet wall tiles, floor tiles, and bar jars; Classification of detergents: (alkaline detergent) 1. Dishwashing liquid: Dishwashing liquid is The most widely used cleaning agent, ordinary dish soap is suitable for decontamination in any environment. When using it, dilute it with water (20-40) times according to the needs of different cleaning tasks. Spray the appropriate concentration of dish soap on the stains and wait a moment. After a while, wipe it with a wet surface or sponge. Some objects should be wiped with clean water after wiping them with detergent solution to prevent residual detergent from damaging the items. Dishwasher detergent is slightly alkaline, with a pH value of about 8. .

2. All-purpose cleaners (multi-purpose cleaners) All-purpose cleaners can be divided into three types, acidic, neutral, and alkaline; 1. Acidic: This product is specially used to remove rust and dirt on the surfaces of bathroom sanitary ware, ceramic tiles, floor tiles, etc. , first remove the sand and dust stains on the surface, mix the acidic detergent and apply it on the cleaning surface, wait for a few minutes, then scrub with tools, and finally rinse with clean water, add water at a ratio of 1:10-1:15; 2 , Alkaline: This product is an alkaline decontamination and degreasing agent that can remove general stains on floors, glass and furniture. Mix it with water in a ratio of 1:10-1:30, clean it with brushing, and then wipe it dry; 3 , Neutral: This product contains a neutral formula and can be used on various surfaces that are prone to corrosion, such as marble, wax surfaces, etc. Dilute with water at a ratio of 1:10-1:30, and use it with a floor mop; 3. Glass water is specially used to clean glass and porcelain. It can remove stains on the glass surface. After cleaning, you can avoid rinsing with water, making the glass crystal clear. It is especially effective in removing general stains, oil stains, smoke, etc. Use it Mix water at a ratio of 1:30 to clean glass and ceramic tiles; 4. Caustic soda, also known as sodium hydroxide, is a powerful decontamination and degreasing detergent, especially suitable for household oil. Caustic soda is highly corrosive. Wear rubber gloves when using it. , dissolve it first when using it, and dilute it to a certain concentration, and wear a mask when diluting it; 5. Green water is a detergent with strong decontamination ability, suitable for washing stubborn stains and dirt, and has a dissolving effect on wax. It should be diluted with water when used, mainly used for cleaning aluminum composite panels; 6. Degreaser is a cleaning agent specially used to remove oil stains, and it should be diluted with water when used; 7. Carpet cleaner is a cleaning agent specially used for cleaning carpets, and there are many varieties In terms of foam produced by wiping it, there are high-foaming, medium-foaming and low-foaming carpet water. The uses are divided into: high-foaming and medium-foaming detergents. Once rubbed on the carpet, almost all of it will be foam. This can reduce the moisture entering the carpet and only clean the carpet. For surface cleaning, carpets are generally cleaned with low-foaming detergents and spray-type carpet cleaning methods. Too much foam in high-foaming and medium-foaming carpets will hinder cleaning; Usage: Carpet cleaners are concentrated liquids, so please clean them before use. Dilute the potion in a ratio of 1:20; 8. Wax-removing water has strong stain-removing and wax-removing properties. It is generally used to completely remove old wax and stubborn stains on the ground for re-waxing; Performance: on any wax surface Both have instant breaking and high penetration capabilities, making it a labor-saving and economical product; Usage: First mix this product with water at a ratio of about 1:8, then mop it on the surface with a wet mop, and use it for 5-8 minutes with the Brush machine cleaning; Note: avoid any direct contact with skin, wear rubber gloves when using; specific application: first observe how thick the wax on the ground is, and then decide the amount of potion. If the wax is thick, add an appropriate amount of potion, use boiling water or hot water , after mixing the potion, mop it evenly on the ground with a floor mop, then scrub it with a floor washer at an even speed, and use a water absorber to suck it dry. Then use hot water to clean the entire floor once, then wash it with clean water, suck it dry, and mop it clean. Floor, observe whether there is wax. If there are stubborn stains that have not been cleaned by the floor washer, scrape them off with a blade, and finally clean the floor. Wait for the hair dryer to dry the floor before waxing; 9. Cleaning and disinfectant performance: This It has the functions of disinfection, sterilization and deodorization, and is suitable for use in various public places; Usage: Use after dilution in a ratio of 1:20, used in places where bacteria are prone to survive, to reduce bacteria and microorganisms to acceptable levels, slightly alkaline 10. Carpet cleaner performance: This product can remove various stains, oil stains, lipstick marks, coffee stains, tea stains, etc. directly sprayed on the carpet for a few minutes, and use a clean cloth or soft brush to make circular strokes. method (from the outer ring to the center), wash gently, and then wipe dry with a dry cloth or sponge; 11. Chewing gum stain remover (128 to get stained water) is specially used to remove chewing gum stains, and spray the stained water on the carpet. , after two or three minutes, after the stickiness of the chewing gum disappears, brush the carpet with a clothes brush and wipe it with a dry cloth; Classification of detergents: (neutral detergent) 1. Save copper water Save copper water is specially used for stainless steel , copper surface stains and rust

For spot cleaning, no need to dilute when using, first apply copper-saving water on a towel, and repeatedly wipe the surface of stainless steel or copper; 2. Clean and bright neutral decontamination cleaner, often used for high-end desktop and stone surface cleaning, clean and bright Brilliant is a powdering agent and is a multi-purpose cleaner; first pour a small amount of Brilliant onto a white cloth, then scrub the stains, then wipe clean with a damp cloth and wipe dry; 3. Tenna Water (Fragrant Glue) ) It is a very strong chemical cleaner with an odor, mainly used for cleaning paint and glue stains on metal or glass surfaces; for example: door handles, door glue, and paint around doors and windows. They are highly flammable liquids, so you must be careful. Use, do not use it on any plastic and rubber substances: such as wallpaper, walls, wooden door paints, stickers, etc.; 4. Foaming agent This product is specially used to eliminate scrubbing machines, water suction machines, automatic floor washing machines and other mechanical operations. Various foams produced; 5. Moisturizing hand sanitizer, this product has a fragrant smell, pleasant color, does not hurt the skin, does not need to add water, is a neutral formula, has skin care effects after long-term use, and is mainly used in high-end toilets; 6. Stainless steel maintenance agent This product is specially used for cleaning and maintaining the surface of stainless steel decorative objects. It can remove oil stains, adhesive dust, fingerprints, smoke marks and markings on stainless steel. After use, it will be clean and bright, forming a protective film to keep the product smooth and free from corrosion. Shake this product Spray evenly and directly on the surface of the product, and scrub with a rag until it is bright; 7. Electrostatic vacuum cleaner This product is made of a variety of high-quality cleaning agent raw materials. It uses the physical effects of polar molecules to make the product have excellent dust collection effects. , does not damage the ground and does not react easily with wax, and is an ideal product for cleaning; Usage: Before use, you need to use a spray bottle to spray this product on the dust pusher. After drying, you can work on the ground. After use, add the dust pusher If shaken vigorously, the dust will fall off on its own. The dust pusher should be rotated and stored in a ventilated and dry place. The dust pusher and this product must not be mixed with water; 8. Extra strong sealing wax (base wax) can firmly adhere to the ground and form a Protective film, this product is suitable for various floors such as marble, granite, sky, unglazed ceramics, etc. Clean the floor, and after it is completely air-dried, use a wax mop to spread this product thinly and evenly on the ground in the same direction, and wait until After the first layer of wax is dry, use a polishing machine to polish it, and then apply the second layer. Generally, two layers of wax are applied; 9. Super glossy wax. This wax is wear-resistant, anti-slip, and anti-pollution, and has strong decontamination power. , can protect the stone surface, make it smooth and bright, and has excellent recoating performance. The usage is the same as that of base wax; 10. Cleaning and maintenance spray polishing wax (polishing wax). This product contains thermoplastic and resin, which has the function of cleaning and filling light. Use it on all kinds of undamaged wax surfaces. Spray a little milky white on the ground, and use it with a high-speed polishing machine to remove stains on the ground and refill the wax. 11. Bilizhu is mainly used to clean all kinds of wooden furniture, It contains stains and dust on the surface of leather, marble and other objects. It contains a variety of silicone oil and concentrated milk wax. It is easy to use and has functions such as decontamination, dust removal, and waxing.