Some people say that its use method is also exquisite?
Yes, the use method of one-button start is as follows: after getting on the bus, press the one-button start switch first, and the car audio system, lighting and other electrical appliances will work, and then step on the brake to start the engine.
It turns out that pressing a key to start the switch first is to energize the electrical system of the whole vehicle, including the fuel supply system, which can replenish the gasoline that may be lost for a period of time because the fuel circuit does not work, and ensure the normal fuel supply of the gasoline oil circuit before ignition.
However, as the saying goes, the weather is unpredictable. What if one day you come to the garage happily and drive, only to find that the one-button start is "out of order" and there is no response? What happened?
First of all, we must confirm whether it is a human cause. This is very important for driving away small white and big head shrimp.
Generally speaking, there are several situations that often go wrong:
1) See if the key is with you, because one-button startup is induced by the key, and it can't be started without the key. If the co-pilot takes the key temporarily, you will have to wait alone.
2) Check whether you have made mistakes. If the whites just press the button instead of braking, the car will be electrified, but the engine will not start. There is also a case where the pressing time is not long enough, or it is not pressed to the end.
3) The gear is not in P gear.
Then there is the problem of "invalid induction".
1) Car keys are often placed next to mobile phones, computers, televisions and other electronic equipment, resulting in low-intensity radio waves in the keys being disturbed, or there are strong radio waves nearby at this time, such as TV towers, airports, power plants, etc. And there will be a phenomenon of "failure" when one button is started.
2) The car keys are dead. If the remote control distance of the key is shortened and the sensing is insensitive, it is a sign that the car key is running out of power. When there is no power, the one-button start function cannot work normally, so the battery should be replaced as soon as possible.
3) The car broke down. For example, there is an oil circuit problem, the battery is dead, and the electronic components are short-circuited. Don't think about it, just call the 4S shop staff directly!
The key doesn't work. What should I do if I want to start the car?
First of all, you can open the door by inserting the car key directly into the keyhole (the keyhole of some cars is hidden under the door handle, so we pry the lid open with the key head first, and then insert it into the keyhole to unlock it). After entering the car, different models have different operation methods. Because the scene can't simulate the situation that the key can't be used normally, we can only read the instruction manual to give you an example, taking our long-distance test vehicle as an example (the following methods are not applicable to spare keys):
Lei Ling (Toyota): Put the P gear on the brake-stick the rear of the locking and unlocking buttons of intelligent key on the one-button start switch-when the buzzer sounds, the engine is in ACC gear-press the brake hard, and check that the sign of intelligent key detection is displayed on the dashboard-press the one-button start switch.
BYD S7 (BYD): Press the start button, the warning light of the intelligent key system will light up, and the buzzer will ring once-stick the key on the start button within 30 seconds, and the buzzer will ring again to remind you to start the engine-and start the engine within 5 seconds.
Chery Tiggo 5 (Chery): Put intelligent key flat on the bottom of the back cup holder, with intelligent key facing up. After putting it away, don't step on the brake-press the start switch, and the dashboard message prompts that the verification is successful-step on the brake, press the start switch and start the engine.
Na Zhijie You 6 (Na Zhijie): When you open the door with a mechanical key, the car will give a danger alarm and the danger warning light will flash. When getting on the bus, put the triangular mark end of intelligent key near the one-button start switch, and press and hold the switch for more than 5 seconds until the alarm sound and danger warning light stop and the anti-theft function is released. Press the start key continuously to switch between off, acceleration and on.
……
In fact, a thousand words can be solved in one sentence: "read more instructions and think more." Instructions are often kept in the car in case of emergency. Call the 4s shop in an emergency. "
It is very convenient to start with one button. What should I do if I want to install it?
Generally speaking, one-button start is a successful invention, which is convenient for us to start the car. Your car doesn't have this function, and there is no need to install it. In the long run, the installation of one-button start-up involves car theft prevention, keyless entry, radio wave induction, circuits and other problems, which may easily lead to minor problems in later use, and it will be even worse if you buy inferior products. If you are really a baby who likes to play tricks, you can also go to the local 4S shop and ask if you can provide extra equipment. Or go to a professional refit shop and use better quality products.
I hope I can help you, and I hope to adopt it!