10X
10 1: Interrupt failed.
102: Clock failure
103: Time interrupt failed.
104: Protection mode failed.
105: The last 8042 command was not accepted.
107: NMI detection failed.
108: Clock bus detection failed.
109: motherboard of low Meg chip selection detection system. nanometre
1 10: If there is an extension connected to the computer, please remove the system motherboard.
1 1 1: I/O parity check memory expansion unit or port Replicator system motherboard.
1 1XX
11kloc-0/:The motherboard of the communication wiring system of serial port equipment failed to detect Class A equipment.
12XX:
1201:motherboard of class b fault detection system (infrared)
158: Even if the administrator password is set, the hard disk password is not set.
159: The hard disk password is different from the administrator password. Set the hard disk password to be the same as the administrator password.
161:standby battery system motherboard for CMOS battery fault detection.
163: Time and date have not been set. Set the time and date of the system motherboard.
173: device data is lost. Select OK on the screen, and then set the time and date to reserve the battery.
System motherboard.
174: setting error: first check the list of installed devices, and then change the FRU parts. Check the device and configure the hard drive system motherboard.
0 175: CRC 1 error, stop the POST task. EEPROM check error. System motherboard.
0 177: System motherboard with incorrect password check.
0 178: EEPROM fault system motherboard
17XX
170 1: Hard disk controller failure.
1780, 1790: Error in hard disk 0.
178 1, 179 1: hard disk 1 wrong hard disk drive system motherboard.
183: When prompted, the administrator password is incorrect.
184: Incorrect startup password check. Enter BIOS settings to reset the boot password.
185: illegal startup sequence. Enter BIOS setup to reset the boot order.
186: 1 system motherboard
0 187: EAIA data reading error. Unable to read EEPROM. System motherboard
0 188: illegal RFID continuous information area or CRC2 error. Error in EEPROM verification. System motherboard
0 189: illegal RFID continuous information area. Error in EEPROM verification. System motherboard
0 190: The battery is charged incorrectly due to extremely low battery power.
0 193: RF antenna has been removed. Enter the supervisor password.
0 194: Take a notebook and enter the supervisor's password through the security door.
0 195: Security hardware is disturbed. Enter the administrator password and enter the BIOS setup tool. Select Configure, IBM Security Chip, and Clear IBM Security Chip to clear this error.
0 196: the security hardware was removed. Enter the administrator password and enter the BIOS setup tool. Select Configure, IBM Security Chip, and Clear IBM Security Chip to clear this error.
0 197: illegal remote modification requires remote configuration of security chip. Please confirm the operation and try again.
0 1C8: Multiple modem devices-remove one of them and press Esc to continue. Remove the MiniPCI modem card or modem daughter card, or press Esc to ignore the error and continue. System motherboard
0 1C9: Multiple network devices-delete one of them and press Esc to continue. Remove the MiniPCI Ethernet card or Ethernet daughter card, or press Esc to ignore the error and continue.
System motherboard
0200: Hard disk error. The hard disk is broken Reinstall (remove) the hard disk in the BIOS setup tool and restore the default settings of the hard disk system motherboard.
02 1x: keyboard misoperation interactive keyboard and auxiliary input device test
0220: Wrong monitor type. Monitor type does not match CMOS definition. Restore the default settings in the BIOS setup tool.
0230: Mapping memory error. There is an offset nnnn error in the mapping. System motherboard
023 1: System memory error. There is an error in the offset nnnn in the system memory. Memory system motherboard
0232: Extended memory error. Error expanding memory with offset nnnn. Memory. System motherboard.
0250: System Battery Failure-System Battery Damage. Replace the spare battery and run the IBM BIOS setup tool to reset the date and time.
025 1: system CMOS check error-the default setting is to replace the spare battery and run the IBM BIOS setup tool to reset the date and time.
0252: Incorrect password verification-the password has been cleared and entered into the IBM BIOS setup tool to clear the password (reset).
0260: System time error. Replace the spare battery and run the IBM BIOS setup tool to reset the date and time. System motherboard
0270: The real-time clock mistakenly replaced the spare battery, and the date and time were reset by running the IBM BIOS setup tool. System motherboard
027 1: Wrong date and time. The computer has not set a date or time. Run the IBM BIOS setup tool to reset the date and time.
0280: Incomplete boot error-The default setting uses the IBM BIOS setup tool to restore the default memory. System motherboard
02B2: Incorrect Drive A Disk Drive External Floppy Disk Drive I/O Card
02F4:EISA CMOS is not writable. Enter the IBM BIOS setup tool and restore the default settings.
Replace the backup battery system motherboard.
02F5: Memory test failed. Memory. System motherboard
02F6: Software NMI memory failure. System motherboard
02F7: Fail-safe timer NMI memory failure. System motherboard
180 1: The connected docking station does not support turning off the computer and then moving it.
1802: unauthorized network card insertion-install and then remove the miniPCI network card. Remove the miniPCI network card. System motherboard symptom or error FRU or operation (pay attention to the order).
Device address conflict:
Device address conflict recovery BIOS setup tool backs up the default settings in the battery system motherboard.
Device allocation error:
Device positioning error: restore the default settings in the BIOS setup tool of the backup battery system motherboard.
Failed bit:
Nnnn bit fault memory slot DIMM system motherboard
Invalid system configuration data:
Illegal system configuration data memory slot DIMM system motherboard
I/O device IRQ conflict:
I/O device IRQ conflict restores the default settings in the BIOS setup tool Backup battery system motherboard.
Operating system not found:
No Operating System Check whether the operating system is error-free and installed correctly.
Enter the IBM BIOS setup tool and check whether the hard disk or floppy drive correctly recognizes the reset hard disk.
Reinstall the operating system floppy disk drive hard disk drive system motherboard
Hibernation error:
The hibernation error recovery system is set to the state before hibernation.
If the memory capacity changes, re-create the hibernation file (delete the hibernation file under c:\ and press enter).
Fan error:
Fan error fan
Thermal induction error:
Thermal induced error system motherboard