legal analysis

if the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable to the supplier and unfair. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and it is agreed that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, according to their needs, establish standards of measurement used by their own units, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. The metrological verification shall be carried out on the spot in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.

Legal basis

Articles 37 and 39 of the NPC Standing Committee's Decision on Amending the Trademark Law of the People's Republic of China are changed to Article 53, which is amended as: "If any of the acts listed in Article 52 of this Law infringes on the exclusive right to use a registered trademark and causes a dispute, the parties concerned shall settle it through consultation; Unwilling to negotiate or failing to negotiate, the trademark registrant or interested party may bring a suit in a people's court or request the administrative department for industry and commerce to handle it. When the administrative department for industry and commerce finds that the infringement is established, it shall be ordered to immediately stop the infringement, confiscate and destroy the infringing goods and tools specially used for manufacturing infringing goods and forging registered trademark marks, and may also be fined. If a party refuses to accept the decision, he may bring a suit in a people's court in accordance with the Administrative Procedure Law of the People's Republic of China within 15 days from the date of receiving the notice of handling; If the infringer neither brings a suit nor performs it within the time limit, the administrative department for industry and commerce may apply to the people's court for compulsory execution. The administrative department for industry and commerce may, at the request of the parties concerned, mediate the amount of compensation for infringement of the exclusive right to use a trademark; If mediation fails, the parties may bring a suit in a people's court in accordance with the Civil Procedure Law of the People's Republic of China. "