Method/steps:

1. Metal needle removal method: You need to prepare a metal needle or toothpick (the thinner, the better), and an eraser. Pay attention to gently lifting it from one end (be careful not to exert force in the direction of the object being attached, but be sure to exert force outward). In this way, it is possible to pick off a larger area at once (don't let the dropped labels fall on other things, otherwise it will become secondary pollution). There will also be residual glue when the strength is different. In this case, just use an eraser to wipe it gently (pay attention to the location where the eraser falls).

2. Eraser. For some surfaces with residual adhesive marks, you can also wipe them with an eraser, and then remove the hair left by the eraser.

3. Prune directly. If there is stubborn adhesive on the carpet, you can carefully trim off the adhesive traces on the top of the carpet pile without affecting the quality of the carpet.

4. For the self-adhesive on plastic products, you can use the hot setting of a hair dryer to heat the self-adhesive, and then slowly tear it off. However, almost every household has a hair dryer, and using a hair dryer can also get rid of annoying labels. Use the hot air of a hair dryer to blow onto the label, but keep a certain distance and do not get too close or continue blowing for too long. When the label is slightly hot when you touch it with your hands, you can use your fingernails or tweezers to try to lift it up from the corners of the label. Since the sticker becomes less sticky when heated, it is easier to peel off than when it is dry. However, it does not change from glue to water after adding heat. The stickiness is still there. When tearing, don't tear it too fast or too hard. You must be careful and patient. It is best to lift the surface at a 45-degree angle to the original surface. " Lift it up, rather than tug and tear it. As long as you are patient, the label can be peeled off intact without leaving any offset marks on the box.

5. Hot water. For the remaining traces, first soak the towel with hot water, then wipe it repeatedly on the sticker traces, then dip the wet towel into soap, wipe it repeatedly on the traces, and finally wipe off the soap suds with a clean warm and wet towel. That's it.

6. Lemon juice. If the stickers get on your skin, you can use lemon juice to remove them.

7. Hand cream. Hand cream can also achieve the effect of removing stickers, because hand cream contains a large amount of water, and the water contains a certain amount of surfactants. This surfactant has good wetting, penetrating and dissolving abilities, and can quickly penetrate between the sticker and the surface of the object to achieve the purpose of removal. Some similar products, such as facial creams, facial cleansers and dishwashing detergents can also be effective.

8. Vinegar removal method. We apply the vinegar evenly on the sticker with a cotton swab. Through the glass, we can immediately see the vinegar slowly spreading between the glass and the sticker. At this time, use a cotton swab to scrape back and forth on the sticker. After a while, the sticker begins to peel off piece by piece, and there is very little residual component of the sticker on the glass. Once wiped with paper, it will be smooth and clean. New.

9. Edible oil removal method. Reserve a spoonful of cooking oil and apply it evenly on the label (fragile labels will lose their stickiness under the influence of oil). After 3 to 5 minutes, you can slowly peel it off from the corner of the label with your hands, so that no trace of the label will be left.

10. Nail polish remover removal method. Use nail polish remover to remove adhesive marks on hard surfaces, such as stainless steel basins or glassware, apply a small amount of water to the overall fragile label, and gently scrape off the label that will fall off with your fingernail. Then use a cotton swab dipped in a small amount of nail polish remover and apply it to the remaining glue on the label. After 1 to 2 minutes, gently rub the remaining glue and it will fall off. These methods do not damage the object being attached and can cleanly remove the self-adhesive labels. We can also tear off the label and apply grease-free nail polish remover to the surface of the object, and then wipe it gently with a soft cloth.

11. Alcohol removal method. The effects of the above solvents are not very obvious. After applying the solvent, we still need to wipe the residue on the glass vigorously. But when alcohol was used, things immediately changed. We brushed the sticker on the glass with alcohol and immediately saw that the sticker slowly softened and dissolved. Gently peel it off with your hands, and the sticker will cleanly leave the glass.

Safflower oil and gasoline can also be used to remove these traces.

12. Fengyoujing removal method is the most effective method for removing stubborn stains left by self-adhesive labels. Fengyoujing is very effective in removing stickers. The Fengyoujing can be soaked into the sticker traces. Slowly, we felt that the sticker softened, and some of the sticker had been scraped off. As we continued to apply and scratch, the reaction between the two became faster and faster. In about 2 minutes, a piece of self-adhesive was removed. Then wipe it with a clean cotton cloth and the sticker will come off. Fengyoujing has a corrosive effect on plastics, and some plastic surfaces will become stained after use.