1. First, cut off the parts that are easy to tear off with scissors, and keep the parts that are stuck too tightly. Soak the bottle in a clear water basin so that the remaining labels can absorb enough water. After soaking thoroughly, brush off most of the wet labels. Then gently wipe off the remaining labels with a metal cleaning ball.

2. Tear off the label paper from the bottle to be processed, and then there will be a layer of sticky substance. Next, we will drop a few drops of ointment and rub it with our hands or other substitutes. It will be much cleaner after rubbing. Finally, clean with clear water, then clean with detergent again, and then clean with clear water.

3. Blower: Blow with a blower for 15 minutes, and then tear off the label. Alcohol: First, tear off the paper layer of the label, dip the towel in alcohol, rub it on the surface, then clean it, and then clean it again with detergent. Nail polish remover: first, tear off the paper layer of the label and dip a cotton swab in nail polish remover, which is easy to clean.

on the adhesive tape to be torn off, apply a proper amount of hand cream. Then in half a minute, rub your fingers on the surface of the adhesive tape. After half a minute, gently uncover the adhesive tape and wipe off the remaining glue traces. In this way, a perfect plate without glue marks appeared. Thermal expansion and cold contraction are used to increase the temperature of the blower.

after turning on the switch and letting it stand for 1 seconds, blow the blower to the adhesive tape on the board for half a minute, touch the surface temperature of the adhesive tape, and tear the adhesive tape when it is slightly hot. However, it should be noted that this method cannot be used if the container itself is not heat-resistant. High temperature heating may melt and deform the container, and even release toxic gases, which is very harmful to human health.