Legal analysis
If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.
legal ground
Article 57 of the Trademark Law of People's Republic of China (PRC) commits any of the following acts, which are all violations of the exclusive right to use a registered trademark: (1) using a trademark identical to its registered trademark on the same commodity without the permission of the trademark registrant; (2) Without the permission of the trademark registrant, using a trademark similar to its registered trademark on the same kind of goods, or using a trademark identical with or similar to its registered trademark on similar goods is likely to cause confusion; (3) selling goods that infringe upon the exclusive right to use a registered trademark; (4) Forging or unauthorized manufacturing of registered trademark marks of others or selling forged or unauthorized registered trademark marks; (five) without the consent of the trademark registrant, the registered trademark is changed and the goods with the changed trademark are put on the market again; (6) Deliberately facilitating the infringement of the exclusive right to use a trademark of others and helping others to commit the infringement of the exclusive right to use a trademark; (seven) causing other damage to the exclusive right to use a registered trademark of others.