1. Round cake road: Adjust the vehicle so that the tangent line of No. 1 and No. 2 cakes is on the right side of the left rib of the car. When No. 3 cake reaches the lower left corner of the front windshield, the direction Beat to the left, keeping your eyes on pie No. 3. When the pie is almost in the middle of the car, return to the straight direction (two turns). Then, look at pie No. 4. When pie No. 4 reaches the lower right corner of the front windshield, Turn to the right and keep your eyes on pie No. 4. When the pie is almost in the middle of the car, return to the straight direction (two turns). Then, look at pie No. 5. When pie No. 5 reaches the position of the left rearview mirror, Turn to the left and keep your eyes on pie No. 5. When the pie is almost in the middle of the car, return to the straight direction (two turns). Then, look at pie No. 6. When pie No. 6 is in the middle of the right wiper blade, Turn to the right and keep your eyes on pie No. 6. When the pie is almost in the middle of the car, return to the straight direction (two turns), and finally drive while looking at the road.

2. Single-sided bridge: Use the left rib on the front cover of the car to press the middle of the left bridge. Wait for one second after the left front wheel is completely under the left bridge (that is, the left (the rear wheel has not yet come off the axle), make one circle to the right. When the left rib is aligned with the left side of the right axle, make two circles to the left. Wait until the midpoint of the front of the car cover is aligned with the left side of the right axle. At this time, the direction goes back to the right (back to normal), and the midpoint is always pressed to the left side.

3. Right-angle turn: Right-angle left turn: Before entering the right angle, the car keeps to the right. When the small flower on the triangular window on the left front door of the car meets the pole, the direction is to the left (two turns) ), the road goes straight back to the right place. Right angle for a right turn: Before entering the right angle, keep the car to the left. When the edge of the right rearview mirror on the right front door of the car meets the pole, turn to the right (two turns) and the road will go straight.

Remarks: When I was practicing at the driving school, the master also taught the second method: turning right at a right angle. Before entering the right angle, keep the car to the left and wait until the small flower (i.e. trademark) on the triangular window of the right front door of the car "aligns" "When extending the line at right angles to the ground (horizontally), turn the direction to the right (twice) and the road will return to the straight line. It's a huge success every time. Please learn it carefully, there will be absolutely no mistakes

4. Driving in a curve: Before entering the left bend, the vehicle should keep to the right, and use the left front corner of the car to keep pressing the right line. When it is time to change to the right bend, the direction Return to the straight line, enter the right bend, and keep pressing the left corner with the right front corner of the car. When you are completely out of the curve, return to the straight direction. Before entering the right bend, the vehicle keeps to the left, and the right front corner of the car keeps pressing on the left line. When it is time to change to the left bend, the direction returns to the straight direction, enters the left bend, and the left front corner of the car keeps pressing on the right line, etc. Completely out of the curve, the direction is back on track.

5. Parking on the side: When the vehicle is backed up and you see pole 1 in the middle of the last triangular window on the right side of the car, turn to the right, then look at the left rearview mirror, wait until the second When the pole comes out, turn to the left (two turns), then look at the right rearview mirror. When pole 1 is directly behind the right rearview mirror, turn to the left to see where the car and the warehouse are. When the side lines are parallel, stop (no direction). Exiting the warehouse: Drive the car forward. When the right front corner of the car is aligned with pole 1, turn the direction back to the right (two turns). Then when the front right corner of the car is parallel to your shoulder, turn the direction back to the right for 1.5 turns. The road is straight and straight.

6. Parking and starting at fixed points on uphill slopes: Parking: When you hear the command, apply the brakes lightly, turn on the right turn signal, look at the right rearview mirror (whether you can pull over), turn to the right, When the center of the front of the car hits the sideline, turn to the left. When the midpoint of the front of the car is 10 centimeters away from the sideline, return to alignment and maintain the distance from the sideline. When the target is reached, brake the car and tighten the handbrake. Starting: Shift to first gear, turn on the left blinker, honk the horn, tighten the handbrake, release the brake, slowly lift the clutch, and when the front of the car is slightly raised, lightly accelerator, release the brake, and start.

7. Shifting for 100 meters: start from 1st gear, lift the clutch, immediately step on the accelerator to the end, then lift the accelerator, step on the clutch, upshift, and so on, until 4th gear , shift to 4th gear before 50 meters; after depressing the clutch, shift to 5th gear; after engaging 5th gear, immediately return to 4th gear and apply the brakes; depress the clutch, return to 3rd gear, and apply the brakes (you can keep your foot down) on the brake!!!), up to 2nd gear.

8. Speed ??limit and width limit gate pass: Pass at a speed of more than 20 kilometers per hour. When passing the first gate, turn 1/4 turn to the left; when passing the second gate, turn the direction Make a half circle to the right; when passing the third door, make a half circle to the left. During the entire process, be careful not to let the window mirror hit the sign pole. (The second method is to accelerate in advance and shift into 3rd gear, and use the idle speed in 3rd gear to pass through the speed limit and width limit gate. Because the idle speed in 3rd gear can already reach 20km/h, there is no need to step on the accelerator.)

9. Ups and downs: Pass in 1st gear, and go slowly! ! (Editor-in-Chief Taotao)