The trademark on the crystal pot is made by printing and hot stamping processes, so special care needs to be taken when cleaning to avoid scratching or wearing off the trademark. Below I give some methods to help you remove the trademark from the crystal pot without leaving any scratches.

We can use mild detergent to clean the trademark on the crystal pot. Choose a cleanser that is non-irritating and contains no acid or alkali ingredients. Pour it into warm water and dilute it. Use a soft sponge or cloth to soak in an appropriate amount of cleaning solution. Then wipe the trademark gently with moderate attention to avoid scratches caused by excessive force.

You can try using toothpaste to remove stains on the trademark. Squeeze an appropriate amount of toothpaste onto a sponge or cloth, and then gently wipe the trademark area. Toothpaste has certain decontamination capabilities and will not cause damage to the crystal pot. But it also requires moderate attention to avoid scratching the trademark.

You can choose to use a soft-bristled brush when cleaning. Use a soft brush with dense bristles and gently brush the trademark area. It can remove stains without causing obvious wear and tear on the trademark. But you need to pay attention to the angle of using the brush to avoid using too much force.

If the above methods cannot completely remove the stains on the trademark, you can try to use a professional crystal pot cleaner. There are some products on the market specifically designed for cleaning crystal pots. Please read the instructions carefully before use and follow the instructions. These cleaners typically have mild yet effective stain-removing properties, allowing them to thoroughly clean crystal pots without damaging the label.

Remember before using any cleaner or tool, please test it in an inconspicuous location to ensure that it will not cause damage to the crystal pot and trademark. During the cleaning process, pay attention to keeping your hands dry and holding firmly to avoid accidental injuries caused by sliding.

To summarize, in order to thoroughly clean the trademark on the crystal pot without leaving scratches, we can choose to use mild detergent, toothpaste, soft brush or professional crystal pot cleaner. Pay moderate attention, keep your hands steady when operating, and test before use. I hope the above methods can help you solve the problem and make the crystal pot's trademark look brand new.