1. Wipe it with a paper towel dipped in some alcohol (preferably industrial alcohol, whether it is medical or not), and then it will be clean after a few rubs.

2. use acetone. The method is as above. The dosage is small and thorough, and the best thing is that it can remove these residual gums very quickly and easily, which is better than sprinkling. These two kinds of solvents are the best among all methods.

3. Use nail polish remover. The usage is the same as alcohol acetone. The effect is also very good. Nail polish remover does not require quality, good or ordinary, as long as it can wash off nail polish.

4. Use hand cream. Tear off the printed product on the surface first, then squeeze some hand cream on it, and rub it slowly with your thumb. After rubbing for a while, you can rub off all the adhesive residue. Just slow down. Hand cream belongs to grease, and its properties are incompatible with rubber. Glue removal is to use this feature.

Because most of the adhesive left on shoes is used by trademarks, the adhesive of trademarks is easy to remain on the soles after the labels are torn off, and it is easy to absorb dust and other impurities after being left for a long time, so it needs to be removed in time.

1. scrape off the adhesive as much as possible, but it may damage the leather on the surface of the shoes. Be careful not to use too much force and try to avoid scratching the shoes.

2. Carefully tear off the labels first and try to keep them intact.

3. If all of them are not torn off and remain on the shoes, pay attention? After blowing hot with a hair dryer, the adhesive softens,

4. Tear it gently while it is hot, and the adhesive left on the trademark on the shoes will be easily removed.