First open the materials and label a box. You can prepare the materials as needed.

The label here is an old man with many lines. If you want to fill a white background with color, how to quickly select the area you need? Use the magic wand tool.

Then add the color you want to the background.

Since the picture is the whole picture and does not have its own border area, you need to add it yourself, using the rounded rectangle tool. Pay special attention to selecting the path mode after selecting the rounded rectangle.

In the Control Panel, under Paths, select Load Selection.

The next step is to stroke.

Because the label is to be affixed to the edge of the box at a right angle of 90°C, we need to cut the label and affix it in half. First use the rectangular marquee tool to select half of the label, and in the layer bar - New Layer - create a new layer by cutting. This way the two halves are on different layers and can be operated independently.

Attach the lower half first, select the picture, right-click, first use Free Transform, so that one side of the label is attached to the side of the box, then right-click and use Distort. Slowly put the label on the box, which requires care and patience. The other half of the steps are the same.

This way both sides can be operated. The label visually looks like it is attached to the box.

The last step is to save. The old rule is to save images directly and save them in PSD format.