1. Generally, there is only one screw at the bottom of the mouse, and there are also screw-free ones that click directly. Gaming mice like to hide the screws under the foot pads or product labels.

2. Carefully observe how many screws there are at the bottom of the mouse. First, remove the obvious screws and try to see if they can be opened.

3. Check whether there are any screws under the trademark film. Use a small screwdriver to remove the screws under the trademark film. Be gentle, the area with screws will be recessed. Tear off the trademark and remove the screws.

4. After removing these screws, lift the upper cover slightly and the front buckle will be very tight. Take it off easily.

The second method;

The most common problem with the mouse is the failure of the buttons. When the mouse buttons are not good or insensitive, we need to disassemble and replace them. Replace the buttons. So how to disassemble the mouse?

Step 1. Prepare the mouse and related tools that need to be disassembled.

Step 2. Here is an introduction to how to disassemble the mouse and find the fixing screws (cross-shaped screws) on the mouse, usually 1 to 3, and they are relatively hidden.

Step 3. Use a flat-blade screwdriver to pry open the lower edge of the mouse. And pull the upper cover of the mouse back hard.

Step 4. Take out the mouse circuit board. See how the mouse is disassembled. In fact, the structure of the mouse is very simple.

Step 5. Use a soldering iron to remove the components that need to be replaced. The problem of how to disassemble the mouse is solved. Here we take replacing the buttons as an example.

Step 6. When replacing components, be careful not to reverse the direction.

Step 7. Finally, restore the mouse according to the steps of how to disassemble the mouse. The problematic mouse is reborn.