Current location - Trademark Inquiry Complete Network - Trademark registration - How to remove self-adhesive stickers
How to remove self-adhesive stickers
Self-adhesive labels are usually attached to machines, computers, metals, plastics and other items or packages for product identification or warranty labels.

It is often difficult for people to tear off this label when necessary. Even if the logo content on the surface can be removed, the glue on the bottom is not easy to remove.

Here are some ways to remove stickers: 1. Metal needle removal method: You need to prepare a metal needle or toothpick (the thinner the better) and an eraser. Pay attention to gently stir it up from one end (be careful not to force it in the direction of pasting the object, but to force it outward). In this way, it is possible to pick up a larger area at once (don't let the dropped label fall on other things, otherwise it will become secondary pollution). There will be residual glue if the strength is different.

2. Eraser: For some adhesive traces left on the surface, you can also wipe them with an eraser, and then remove the Mao Mao left by the eraser.

3. Direct pruning: If there is stubborn self-adhesive on the carpet, you can directly prune the traces of self-adhesive on the top of the carpet fluff carefully without affecting the quality of the carpet.

4. Hair dryer: For the self-adhesive on plastic products, you can use the hot gear of the hair dryer to blow the self-adhesive hot, and then slowly tear it off. However, almost every family has a hair dryer and can get rid of the annoying label. Dry the label with the hot air of the hair dryer, but keep a certain distance, not too close, and don't blow dry for too long. When touching the label with your hands is a little hot, try lifting it from the corner of the label with your nails or sharp tweezers. Because glue will become sticky when heated and tear better than when it is dry. But it doesn't change from glue to water after heating, and the viscosity is still there. You shouldn't tear it too fast and too hard. You must be careful and patient. It is best to "pull" the surface at a 45-degree angle with the original adhesive surface, rather than yanking and tearing it. As long as you are patient, the label can be torn off intact, leaving no trace of offset printing on the box.

5. Hot water: soak the towel with hot water first, then wipe it repeatedly at the sticky mark, then dip the towel with soap, wipe it repeatedly at the mark, and then wipe the soap foam with a clean warm and wet towel.

6. Lemon juice: If these stickers stick to your skin, you can remove them with lemon juice.

7, hand cream: hand cream can also achieve the effect of removing self-adhesion, because hand cream contains a lot of water, and water contains a certain amount of surfactant. This surfactant has good wetting, penetrating and dissolving ability, and can quickly penetrate between the adhesive and the surface of the object, thus achieving the purpose of cleaning. Some similar products, such as face cream, facial cleanser and detergent, also have certain effects.