There are four steps to remove the trademark offset printing on the pot.

First, tear off the trademark label on the bottom or wall of the pot, soak the towel with warm water (hot water is used in winter), and repeatedly wipe the adhesive mark twice.

second, apply toothpaste evenly on the surface of the adhesive and wait for two minutes.

third, wipe it with a soft rag. If it is not clean, repeat it several times. If it's glue on shoes, blow it with a hair dryer.

fourth, some pot bottoms have a lot of self-adhesive stickers, which are firm and cannot be cleaned clearly at one time. Just apply toothpaste on the traces that have not been removed at one time, and then carry out the above first and second steps to remove the self-adhesive stickers.

The essence of this method is that the toothpaste contains glycerol, because glycerol is a good dissolving agent, which can dissolve the components of the adhesive, so it can be extended to many daily necessities. The effect of wind oil essence can also be used. If it is a self-adhesive sticker or the like, it can be removed by blowing with a hair dryer, and it can also be wiped with a wet rag dipped in alcohol or spirit Erguotou.

Apply all kinds of skin care products such as face cream and face oil to the trademark. After the skin care products are applied to the trademark later, they will be peeled off gently, and even the offset printing will not be left.