No.

The etc card is processed based on vehicle information, that is, it needs to be identified by the license plate number. One etc card can only correspond to the license plate of one vehicle, and cannot identify multiple license plate numbers. If you have several cars at home, you need to apply for an etc. credit card for each car according to the license plate number.

1. If you are replacing a vehicle without changing the license plate, you only need to remove the original etc equipment from the previous vehicle and install it on the replacement vehicle. Then bring the relevant documents, equipment, and driving vehicle to the bank etc. processing point to re-enter the vehicle information and activate it.

2. If you change the license plate when changing the vehicle, the etc card on the car will be of little use. You need to unbind the original etc credit card, cancel the etc information, then bring the relevant documents, drive to the bank branch to apply for the etc device again, and re-bind the etc card to the device. Extended information

The installation height of ETC equipment requires no less than 1.2 meters and no more than 2.5 meters. The installation angle N should be between 30° and 90° (the angle between the electronic tag surface and the horizontal plane). The installation position of OBU equipment in small vehicles such as cars and vans is at the middle and upper part of the front windshield level, while the installation position in large vehicles such as large trucks and buses is in the middle and lower part.

For vehicles with explosion-proof membranes or explosion-proof membranes installed later, because the explosion-proof membrane contains metal ions, it will affect the signal transmission of the microwave communication link, so it should be installed in the "microwave skylight" belt, or Open a rectangular area of ??8cmX10cm for the explosion-proof membrane.

ICBC China website-ICBC ETC Credit Card