Jaragar watches are brand-new and high quality, made of waterproof tape on the front, cowhide on the back, and high-quality toughened, wear-resistant and scratch-resistant sapphire crystal glass.

Jaragar watch is a mechanical automatic movement imported from Russia. The dial is atmospheric, domineering and cost-effective, but the dial is complicated, inexpensive and cost-effective.

Extended data:

Suggestions on the use of jaragar mechanical watch;

1. Watch with manual winding movement should be wound at the same time every day as far as possible, so that the watch has enough energy to run in the next 24 hours.

2. The energy of the watch with automatic winding movement comes from the movement of the wearer's arm, and it is not necessary to wind it manually under normal wearing conditions. Only when the wearer's exercise is not enough to replenish enough energy for the clockwork, can it be compensated by manual winding, and the crown rotation is controlled within 20 turns when winding.

3. For a self-winding watch that has not been worn for more than 40 hours, when it is worn again, turn the crown 20 times and start the drive system of the movement again.

4. To prevent moisture from penetrating into the case and keep the watch waterproof, please ensure that the crown is always locked.

Adjustment time of mechanical watch:

When the mechanical watch is left standing for a long time, the spring of the mechanical watch will be relaxed until the watch is still. At this time, if you want to wear it again, you must first re-wind it and then calibrate the time.

At the moment when the spring is loosest, it will show that the hour hand and the minute hand are slow or fast.

Because of this, you should wind up the spring first, so that there is no standard electric pointer after the calibration time. Even for the semi-automatic winding model, it is necessary to manually wind it to eight minutes full (it will jam the spring), and then implement time calibration.