Current location - Trademark Inquiry Complete Network - Trademark inquiry - How to adjust the Mitsubishi system of machining center?
How to adjust the Mitsubishi system of machining center?

Zhongshan Yisuli Machinery Co., Ltd. will answer for you: The operating steps of the Mitsubishi system are as follows:

1. Turn on the machine tool switch - power on button

2 , Return to zero: Turn the knob to ZRN - press the cycle start key, and the three axes will return to zero at the same time. (You can also reset xyz separately: turn the knob to ZRN - press Z,

3. Install the workpiece (pressure plate or vise)

4. Make the meter (flat surface and side) to within 2 wires on the side and within 5 wires on the surface, preferably Hit the verticality again.

5. Center the center rod at a speed of 500.

6. Open the program, look at the tool, and install the tool. Pay attention to the blade length of the tool and the required knife length. Never install it too short. .

7. Simulation program—transmission program.

8. Turn the knob to DNC, feed to 10, and RAPID OVERRIDE to 0—and then quickly switch between 0 and 25 on RAPID. The tool will pause 50mm above the workpiece. Special attention is required when the tool is close to the workpiece. The feed needs to be hit to zero. Check whether the distance between the tool and the workpiece corresponds to the residual value displayed on the machine tool.

9. Finally adjust the speed and feed.