Some don't have screws, but they are fastened. Use a piece of plastic that is hard enough but not sharp enough to pass through the gap in the plastic and try to open the buckle inside.
In the end, I can't do it. I can't help it Find a hammer to hammer him. NND hehe
Question 2: How to turn on the wooden speaker? Carefully remove the net board without gap in front and see if you can find the doorway. This is a kind of, front. Another possibility is to carefully pull the bottom plate and push the back plate up from the bottom. If these two can't be opened, it's because the box is covered with a layer of aluminum-plastic plate, and the joints are very beautiful. If you are a dead horse,
Question 3: How to disassemble the computer wood stereo? You can pry open the front screen frame with a plate tool and put on a new cloth to renovate it. Then remove the horn.
Some speakers have a retainer around them, which is screwed or glued. Remove the retainer first, then you can see the screws for turning the horn, and then unscrew those screws, and the horn can be taken out (generally, you can insert it by removing the largest horn). In fact, there is nothing in it, only some sound-absorbing cotton, frequency divider and wires.
Don't try to destroy the wooden structure, because there are nails between the boards, which are bonded with strong latex, and there are wooden strips inside the speaker to maintain the structure. If the wooden structure is destroyed, it is generally difficult to recover, and a good box will also be destroyed. A speaker with a power amplifier usually has a large metal plate on the back because it needs heat dissipation. Just take off the metal plate.
Question 4: How to disassemble this stereo? Find out where the screws are and use a screwdriver to disassemble them.
Question 5: How to disassemble this stereo? First, remove all visible screws, including those under the trademark label.
Look for seams. These are all plastic buttons. You should pry them open.
Question 6: How to disassemble the small speakers of Tsinghua Tongfang and Tsinghua Tongfang? Try the following methods:
1, if the screw is loose, unscrew it first, and then gently find one side. It is also possible that the screws were hidden. Carefully observe whether there is a round rubber pad around or at the bottom of the speaker. Obviously, if there is a corner, see if there are any screws under it. If so, you can unscrew the screw and take it apart.
2. If it is a bayonet, it is necessary to study how it is stuck. It is best to disassemble in the opposite direction of the bayonet. On the contrary, it may cause the sound box bayonet to crack and cannot be put back.
3. If one side is bayonet and the rest is push-pull type, then choose the side with bayonet and pull it in the direction of taking it away.
Question 7: How to disassemble speakers of different models and methods?
The low-grade horn is integrated, so it should be turned up. Even better, there are screws. Open the panel, find the screw and you can open it.
The power amplifier is usually placed in the bass unit and is basically fixed with screws.
I recommend a stereo to you. Philip, the rambler is good. Philips is more expensive and there are more fakes. Consumers are more passive when choosing, and it is difficult to distinguish. Rambler is cheaper, but it still has shortcomings, that is, it mainly makes low-cost audio, so the sound quality is still lacking and cannot be too demanding. Similar to these two, AB of Bt- Audi Geng is better. Adopt super instantaneous response unit, the high tone is durable, the low tone is not sticky, the strong tone is not dry, and the weak tone is not empty. The warm and mellow timbre shows the infinite charm of music, and you can feel the charming melody of British legend, appreciate the pedigree, sound quality and workmanship.
The style contained in AB bookcase comes from the unique design of BT-audio audio engineer, a desktop HIFI speaker with bedroom and study, with exquisite and elegant appearance. First-class workmanship and sound quality have created the myth of high-end and low price in the audio industry, and completely brought the concept of parity to the extreme!
I hope my answer can help you.
Question 8: How to disassemble the computer stereo? It is broken. If there is no screw, turn it out hard.
Question 9: How to disassemble the enclosed multimedia active speaker? Don't open it. Generally, the circuit board is disassembled after the sound quality is affected.