use banana oil. It is an industrial agent used to remove paint, and it is also easy to buy (where paint is sold, it is sold). The method is the same as alcohol. Two: use hand cream. Tear off the printed product on the surface first, then squeeze some hand cream on it, and rub it slowly with your thumb. After rubbing for a while, you can rub off all the adhesive residue.

just slow down. Hand cream belongs to grease, and its properties are incompatible with rubber. Glue removal is to use this feature. Three: chemical stores have thinners to buy, which have a good effect and can be wiped off soon. Four: Use a paper towel to dip some alcohol (preferably industrial alcohol, whether it is medical or not) to wipe it, and then rub it a few times to clean it.

five: use nail polish remover. Usage is the same as alcohol. The effect is also very good. Nail polish remover does not require quality, good or ordinary, [url=92-11597/] as long as it can wash off nail polish. Six: use. The method is as above. Dosage. Blow the label with a hair dryer, and then you can tear it.

Use an organic solvent, such as alcohol, for heating with a hair dryer. If the adhesive is very sticky, you can use a solvent, such as cyclohexanone, an effective wind oil essence and nail polish remover. It's cheap and good. Before cleaning, look at the introduction of cleaning the label adhesive stuck to stainless steel appliances with nail polish remover. I tried it at home, and I hope it will help you. It seems that it won't work. Just soak it for a while and try to scrape it tomorrow. It should be better.

scald it with boiling water, then dry it with fire, and finally tear it off. Simple, use a cloth in the water, rub it hard for a few times, and it will be clean … just wipe it gently with a little diesel oil. easy! Stick the transparent glue on it, then pull it and stick it again. You will find that the glue in the glass bottle will be sucked by the transparent glue. You can scrub the bubbles with alcohol and gasoline, and then wipe them off with the steel ball that brushes the pot. If there are traces, you can dip a cloth in 95% alcohol, or you can erase them with wind oil, and sometimes you can remove them with an eraser.

Use an eraser to wipe ~ (don't get wet). Blow it with a hair dryer before you tear it off, and then just tear it off. But now that you've torn it, erase the rest with an eraser! Right! It's hard to tear off the trademark on the glass bottle. Both of them are right, but it's a little slow and it won't be clean.

the quickest and cleanest way is to apply some pure alcohol, and then it will be easy to wipe, and it can also be as good as new, without traces. If there is no pure alcohol at home, you can fill the glass bottle with water and soak it in the water. After two or three hours, it will be easy to clean it with the wire ball commonly used in the kitchen. [url=59/] Because the common wire balls in the kitchen won't scratch the glass bottles, you can rest assured to wipe them.