Bag production is very complicated. There are many processes to complete a bag. Each process is very important. If one process is not done well, the bag will be useless. Actually, every process of bag making is very important, and of course there will be some standards to regulate it. As a bag manufacturing and processing factory, Dongxuan Leather Goods also has a set of process standards. After the editor's summary, I will share it with everyone. Hope it helps everyone.

1. License plate: Generally, start the needle at the bottom of the license plate. When tightening, you need to focus on 3-4 stitches. The line is 8-9 stitches per inch. The line is required to be smooth, smooth, and the seam is even. Can't be skewed. Users can observe the stitching around the bag’s trademark to find the problem!

2. Bone pulling: The seam should be even, the corners should not be wrinkled, and the four corners should be even. The aggregate should be close to the core of the bone to avoid broken bones.

3. Installing the hijab: For the needle position car, it must be balanced and not skewed. The line must be straight and the opening must be even.

4. Install the front bag: The front pinhole must be covered, and the needle should be started at the center of the circumference or bottom. The four corners of the installed bag should be parallel and symmetrical.

5. Winding: The stop must be uniform and even, paying special attention to the direction of the zipper. The chain sticker coming out of the car should be flat and not wavy.

6. Barge: Aim at the car, the zipper cannot burst, and the double lines between the two lines must be even and straight. The effect of the barge will directly affect the quality of the buried bag. If the girth is too long or too short, the buried bag will be crooked or wrinkled. In principle, the buried bag must be tested before removing the hidden line, and it can be produced only if it is suitable.

7. Stitching technique: The stitching lines should be aligned towards the hooked edge and rough edges, parallel to the top and bottom, and cannot be skewed.

8. Double-turn hemming: The hemming mouth should not have large thin edges, discounts, or punctures, and the corners should be rounded and smooth.

9. Install side bags: Pay attention to the direction of the slider. When pulling the buried zipper, the slider should be in the front direction. The four corners of the installed bag should be square and parallel up and down.

10. Car strap: Pay special attention to the square card and the center line. Generally, the length of the square card is 1.5 inches. The center line must pass through the intersection and cannot be bent. The folds on both sides of the square card should be even and uniform. Finally, the closing stitches should overlap.

11. Triangular webbing: Generally speaking, if the webbing is not punched with a square card, put it into the triangle material for half an inch. If you need to punch the ribbon with a square card, put about 1 inch of the triangle material.

In order to create a high-quality personalized bag, Dongxuan bag production factory usually needs strong design strength and exquisite production technology. It must have complete and perfect production technology and bag production. The process standards of bag production, advanced computer assembly line production, and high level of modern equipment make the product quality more reliable!