1, integrated toilet, which can be disassembled after rotating the drain to a specific position. Most toilets are like this, and then there is a plug in the exposed part. After unscrewing counterclockwise with a screwdriver, the drain pipe can be completely removed;
2, split toilet, you need to remove the water tank first, there are nuts on the left and right sides of the bottom of the water tank, and the water tank will be removed after it is removed. Needless to say, you will know how to dismantle it later.
How to install the toilet drain valve?
1. Preparation: Measure the toilet and its installation position to ensure that the product size is correct and easy to use. Triangle valve is installed to check whether the groundwater is clean and free of foreign bodies, mainly to facilitate the installation of the toilet and its stability after installation. Marking positioning: put the toilet in the position to be installed and aim at the drain. Draw a line along the edge of the toilet with a pencil, and make clear the specific position after installation so as to fix it with silicone. Be sure to align the toilet with the drain.
2. Flange installation: Before installation, it is necessary to check the quality of the flange to ensure that the flange is not damaged before installation. When installing, it should be placed at the drain, and then fixed with silica gel to ensure no leakage. Flange installation is an important link in the whole process. If the flange is improperly installed, the toilet is likely to leak during use. Fixation: Apply silica gel to the pencil mark on the toilet to ensure that the ground is closely connected with the toilet. In the process of coating silica gel, silica gel must be coated evenly and the surface should be as smooth as possible, so as to ensure that the appearance of dry silica gel gives people a neat feeling.
3. Straightening position: put the toilet back to its original position, and clean up the spilled silica gel at the bottom in time after the position is fixed. Repair the place where there is no joint to prevent future leakage.
4. Connect the water inlet: After the above work is completed, it is necessary to connect the water inlet pipe fittings and the water inlet hose of the toilet. To ensure that the connection point is firm, the pipe body is not folded, and the pipe fittings are not entangled, so as to ensure that there is no water seepage, water leakage or poor running water in the future.
5. Drainage test: After the toilet is installed, conduct a drainage test, adjust the water level of the water tank appropriately, and check whether the water flow is smooth and normal through sound and flow. Of course, if everything is debugged normally, it is recommended not to use the toilet immediately, and try to wait until the silicone is dry before using it, which usually takes 24 hours after installation.