Current location - Trademark Inquiry Complete Network - Trademark registration - How is the magic of putting coins into glass bottles done?
How is the magic of putting coins into glass bottles done?
The following is the teaching of putting coins into bottles, which is the same principle as putting caps into bottles ... Let's start: 1. Prepare props: 2 one-dollar coins, 1 plastic coca-cola bottle, a utility knife, 1 small magnet (magnetic force is required to be strong enough, mine is removed from the earphone of Desheng radio, and the effect is very good), and 1 ring (if you have a professional PK ring, you don't need to prepare a small magnet). Third, wear a ring on the middle finger of the left hand and insert a small magnet into the gap between the ring and the finger. As shown in Figures 2 and 3. Props are ready, and the following is how to perform: Performance steps: 1 Hold the brand with your left hand, and attract the coins in the bottle to the brand with a magnet to show the audience that the bottle looks empty because the coins are blocked by the brand and the hand. As shown in figure 4. Take out another coin with your right hand and show the audience that it is impossible to insert the coin from the bottle mouth. Then put the coin in the palm of your hand, and then forcibly cover the bottle mouth. At this time, the coin will collide with the bottle mouth and make a "bang". At this time, immediately keep the left hand ring away from the bottle, or rely on the impact to make the coin originally attracted to the back of the trademark fall to the bottom of the bottle. At this time, there is still a coin in the right hand. Continue to hide it in your hand and give the bottle to the audience for inspection. Then tell the audience to take out the coins. Hold the bottle upside down, with the left hand (ring) still holding the trademark and the right hand holding the bottle mouth. Try not to leave a gap between your hands (as shown in Figures 5 and 6). Gently shake the bottle to let the magnet attract the coin again (the shaking at this time can make the audience mistakenly think that the magician is looking for a place to let the coin out). At this time, spread out the right hand to show the coin, and then hold the bottle vertically to let the audience think that the coin has been taken out. Before the audience asks for an inspection, immediately "change" the coin into it, and then let the audience inspect it. At this time, the right-hand coin should be hidden in the trouser pocket. The performance is over. Attention to details: 1. When cutting the bottle, it must be along the seam of the trademark, which is slightly longer than the coin. In the performance, the trademark should always be in a horizontal line with the audience's eyes. The water in the bottle doesn't need to evaporate completely, so leave a little inside to make the inner wall of the bottle feel a little foggy, which makes it more difficult for the audience to find the "wound" of the bottle. 4 Right-handed coins should be hidden naturally. More contact with the step of "taking out", which is the difficulty of the whole magic and the key to success or failure. Finally, I wish you success! I'll also send you several video addresses to see many methods/video/zongyi/27-5-25/35811.html.