1.

Metal circular saw machine Tool-Circular Saw Blade Setting

Clean and wipe the flange surface to keep it clean and fresh. Do not install the circular saw blade in reverse. With the trademark side facing upwards, the flange should be locked with M 16 screws.

Clean the circular saw blade and its peripheral parts, fix all parts with screws to prevent loosening, especially the circular saw blade cover, keep the circular saw blade and guide rail clean, and rotate it gently by hand to ensure the smooth rotation of the saw blade.

2.

When installing the wire brush, it must be ensured that the wire brush is aligned with the circular saw blade.

When adjusting the front end of the wire brush, cover the circular serrated bag.

When the circular saw blade rotates, it will be dangerous if you touch it directly with your hands. Please wait for the equipment to stop completely before opening the saw blade cover. When replacing the saw blade, the power supply must be cut off.

Metal circular saw machine saw blade advance setting.

Whether there are undetected parts on the front end of the circular saw blade, the proximity switch on the transverse clamping seat and the saw blade cover, it is necessary to confirm that all circular materials can correspond to each other, and it is not necessary to adjust the position of the rear end to fix the position of the last end. (Note that this scale is made of square or special-shaped steel, so it can't be used, and the saw blade may be damaged at this time. )

3.

When cutting square or irregular materials on metal circular saw machine, move to the switch position of transverse clamping, loosen the screw and adjust the fixing frame according to the actual situation. For example, the square material 15mm-60mm can be cut off. Don't adjust the LS sensor block during the automatic operation of the equipment, but wait until the equipment is completely stationary before debugging, otherwise it is easy to find dangerous accidents!

4.

Cooling of circular saw blade-oil mist

There is lubricant mist R68 at both ends of metal circular saw machine saw blade, and the dripping speed is 10 second.

Don't swallow the oil mist. If it accidentally enters your mouth, spit it out immediately. If it gets into your eyes, immediately flush your eyes with plenty of water. In cold weather, it is necessary to prevent oil mist from freezing and maintain the necessary temperature.

Matters needing attention

Please cut off the power supply during installation to ensure that the equipment does not work.

Do not operate with your bare hands. You must wear special gloves.